Текст страницы
Parameter
Description
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds. If you enter 0, there will
be no delay.
Show Message
Select the Show Message check box to enable a pop-up message in
your local host PC.
Report Alarm
Select the Report Alarm check box to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm
event occurs.
Select the Send Email check box to enable the system to send an
email notification when an alarm event occurs.
Send Email
To use this function, make sure that the email function is enabled in
Main Menu > NETWORK > EMAIL.
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm event occurs.
Record Channel
The recording for motion detection and auto recording function must
be enabled.
Click Setting to display the PTZ interface.
PTZ Linkage
Motion Detect can only activate PTZ preset.
Post Record
Set a length of time for the Device to delay turning off recording after
the alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Tour
Select the Tour check box to enable a tour of the selected channels.
Select the Snapshot check box to take a snapshot of the selected
channel.
Picture Storage
To use this function, select Main Menu > CAMERA > Encode >
Snapshot, in the Type list, select Event.
Select the check box to enable the function. When an alarm event
occurs, the extra screen outputs the settings configured in Main
Menu > DISPLAY > Tour > Sub Screen.
Sub Screen
●Not all models support this function.
●To use this function, extra screen shall be enabled.
Buzzer
Select the check box to activate a buzzer noise at the Device.
Log
Select the check box to enable the Device to record a local alarm log.
25