Текст страницы
EN EN Specifications
Battery Disposal and Removal
Robot
Base Station
WEEE Information
Model
RLD52SE
Model
RCDE0302
The built-in lithium-ion battery contains substances that are hazardous to
the environment. Before disposing of the battery, make sure the battery is
removed by qualified technicians and discarded at an appropriate recycling
facility.
Charging Time
Approx. 3.5 hours
Rated Input
220-240 V 50-60 Hz
– the battery must be removed from the appliance before it is scrapped;
Rated Voltage
14.4 V
Rated Output
20 V
2 A
– the appliance must be disconnected from the supply mains when removing
the battery;
Rated Power
75 W
– the battery is to be disposed of safely.
Rated Power (during dust emptying)
700 W
Operation Frequency
2400–2483.5 MHz
CAUTION:
Rated Power (during cleaning)
40 W
Maximum Output Power
<20 dBm
Before removing the battery, disconnect the power and run out the battery as
All products bearing this symbol are waste electrical and electronic
equipment (WEEE as in directive 2012/19/EU) which should not be
mixed with unsorted household waste. Instead, you should protect
human health and the environment by handing over your waste
equipment to a designated collection point for the recycling of waste
electrical and electronic equipment, appointed by the government
or local authorities. Correct disposal and recycling will help prevent
potential negative consequences to the environment and human
health. Please contact the installer or local authorities for more
information about the location as well as terms and conditions of
such collection points.
much as possible.
Rated Power (during charging and
drying)
87 W
Unneeded batteries should be discarded at an appropriate recycling facility.
Do not expose to high temperature environment to avoid risks of explosion.
Under normal use of condition, this equipment should be kept a separation
distance of at least 20 cm between the antenna and the body of the user.
Under abusive conditions, liquid may be ejected from the battery. If contact
occurs, flush with water and seek medical help.
Note: Rated Power (during charging and drying) is determined by the power
value during full load period.
Removal Guide:
1. Turn over the robot, use a proper tool to remove the screws on the back of
the robot, and then remove the cover.
2. Unplug the terminals between the battery and PCB board to remove the
battery.
20
21