Текст страницы
Note:
Notes:
Starting Cleaning
The robot may not be turned on when the battery
is low. In this case, place the robot to the dock for
charging.
• The actual process may vary due to ongoing app updates.
Follow the guide provided in the app.
• Only 2.4 GHz WiFi is supported.
• If the robot waits more than 5 minutes for a connection,
WiFi will be automatically disabled. If you want to
reconnect, reset the WiFi before proceeding.
Connecting to the App
Press
to start cleaning. The robot will plan
its cleaning route and in each room, it firstly
draws out edges and then fills the room
in a zigzag pattern. In so doing, the robot
cleans all rooms one by one, thoroughly and
efficiently.
1. Download the App
Notes:
Instructions for Use
C
Search for “Roborock” in the App Store or
Google Play or scan the QR code to download
and install the app.
Turning On/Off
Press and hold
to turn on the robot. The
power indicator light will come on, and the
robot will be on standby.
Press and hold
to turn off the robot and
complete the cleaning cycle.
The robot cannot be turned off when it is being
charged.
Note:
C1 Filling the Clean Water Tank
2. Reset WiFi
• To make sure the robot returns to the dock automatically,
start the robot from the dock and do not move the dock
during cleaning.
• Cleaning cannot start if the battery level is too low.
Allow the robot to charge before starting a cleanup.
• Before cleaning, tidy cords (including the power cord
of the dock) and valuables from the floor. Loose
items may be dragged by the robot, resulting in the
disconnection of electrical appliances or damage of
cords and property.
• If cleaning is completed in less than 10 minutes, the
robot will clean the area twice.
• If the battery runs low during a cleaning cycle, the
robot will automatically return to the dock. After
charging, the robot will resume where it left off.
• The robot will retract mop cloth mounts to clean the
carpet. You can also set the carpet as a no-go zone in
the app to avoid it.
• Before starting each cleaning task, make sure that the
mop cloths have been properly installed.
Lift the clean water tank, open its lid, and
then fill it with tap water. After filling, close
the lid, lock the latch, and then put the clean
water tank back to the dock.
Press and hold
and simultaneously
until you hear the “Resetting WiFi” voice
message. The reset is complete when the
power indicator light flashes blue slowly.
The robot will then wait for a connection.
Notes:
Spot Cleaning
Note:
If you cannot connect to the robot due to your
router configuration, a forgotten password, or any other
reason, reset the WiFi and add your robot as a new device.
Press and hold to start spot cleaning.
Cleaning range: The robot cleans a 1.5 m (4.9 ft) ×
1.5 m (4.9 ft) square area centered on itself.
3. Add Device
After spot cleaning, the robot will automatically
return to the starting point and be on standby.
Note:
• To prevent damage, do not use any disinfectant and
only use cleaning solution recommended by Roborock.
• Do not add too much cleaning solution to prevent the
robot from working improperly due to slipping.
• To avoid deformation, only use cold water.
• If any water stains remain on the outside of the
water tank, wipe them with a soft, dry cloth before
reinstalling the tank.
Open the Roborock app, tap the “Add
Device” or “+” button and add your device
following the in-app guide.
37