Текст страницы
D5 Dustbin
* Clean as required.
and at the same time, press the Reset button
until you hear the “Restoring factory settings.
This will take about 5 minutes.” voice message.
The robot will then be restored to factory settings.
D1-8— Reinstall the main brush cover. Make
sure its four teeth are fully seated in
the slots, and press the main brush
cover until you hear it lock with a click.
D5-1—Remove the magnetic top cover of
the robot and press the dustbin latch
to take out the dustbin.
Routine Maintenance
D
D5-2—Remove the washable filter and
empty the dustbin.
Notes:
Notes:
• To securely install the main brush cover, make sure to
press both of the main brush cover latches in place.
• It is recommended to wipe the main brushes with a
wet cloth. If the main brushes are wet, air-dry them
away from direct sunlight.
• Do not use corrosive cleaning fluid or disinfectant to
clean the main brushes.
D5-3—Fill the dustbin with clean water and
reinstall the washable filter. Gently
shake the dustbin, and then pour out
the dirty water.
D2 Side Brush
• The product must be switched off and the plug must
be removed from socket outlet before cleaning or
maintaining the product.
• The frequency of replacement may vary with the actual
situation. If abnormal wear occurs, replace the parts
immediately.
* Clean monthly and replace every 3-6 months.
To prevent blockage, only use clean water without
any cleaning liquid.
Note:
D1 Main Brushes
D2-1—Turn over the robot, unscrew the
side brush, then remove and clean it.
* Clean every 2 weeks and replace every 6-12 months.
D5-4—Allow at least 24 hours for the dustbin
and washable filter to dry thoroughly
before reinstalling them.
D2-2—Align the central groove with the raised
position on the robot, then tighten
the screw to reinstall the side brush.
D6 Washable Filter
* Clean every 2 weeks and replace every 6-12 months.
D1-1—Main Brush Cover
D1-2—Main Brush Cover Latches
D1-3—Main Brushes
D1-4—Main Brush Bearing
D3 Omnidirectional Wheel
* Clean as required.
D6-1—Remove the filter.
D3-1—Use a tool, such as a small screwdriver,
to pry out the axle and take out the wheel.
D1-5—Turn over the robot and press the
two latches inwards to remove the
main brush cover.
D6-2—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
The omnidirectional wheel bracket cannot be removed.
Note:
Do not touch the surface of the filter with hands,
brushes, or hard objects to avoid potential damage.
Note:
D1-6—Lift the main brushes and pull them
out, remove bearings and remove any
entangled hair or dirt at both ends of
the main brushes and bearings.
D6-3—Allow at least 24 hours for the filter to
dry thoroughly before reinstalling it.
D3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Air-dry, reinstall, and press the wheel
and axle back in place.
D7 Mop Cloths
D4 Main Wheels
* Clean as required and replace every 1-3 months.
* Clean as required.
Clean the main wheels with a soft, dry cloth.
D1-7—Reinstall the main brush bearings.
And then, reinstall the main brushes
and make sure the color of the main
brush, main brush bearing and the
arrow on the robot match.
D7-1—Remove the mop cloths from mop
cloth mounts. Clean the mop cloths
and air-dry them.
39