Текст страницы
Restoring Factory Settings
D5 Dustbin
* Clean as required.
D1-9—Reinstall the main brush cover. Make
sure that the four teeth are fully
seated in the slot, and then press on
the main brush cover to lock it until
you hear a click.
D5-1—Open the top cover of the robot and
press the dustbin latch to take out
the dustbin.
Notes:
If the robot does not function properly after
a system reset, switch it on. Press and hold
the button and at the same time, press the
Reset button until you hear the “Restoring
factory settings” voice message. The robot
will then be restored to factory settings.
D5-2—Open the washable filter and empty
the dustbin.
• Main brush should be wiped down with a wet cloth. If the
main brush is wet, air-dry it away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brush.
Routine Maintenance
D
D2 Side Brush
D5-3—Fill the dustbin with clean water and
reinstall the washable filter. Gently
shake the dustbin, and then pour out
the dirty water.
Note:
* Clean monthly and replace every 3-6 months.
The frequency of replacement may vary depending
on the situation. If abnormal wear occurs, replace the parts
immediately.
To prevent blockage, only use clean water without
any cleaning liquid.
Note:
D1 Main Brush
Unscrew the side brush screw. Remove and
clean the side brush. Reinstall the brush and
tighten the screw.
D5-4—Leave the dustbin and the washable
filter to dry.
* Clean every 2 weeks and replace every 6-12 months.
D3 Omnidirectional Wheel
D6 Washable Filter
* Clean as required.
* Clean every 2 weeks and replace the filter every 6-12 months.
D6-1—Remove the filter.
D3-1—Use a tool, such as a small screwdriver,
to pry out the axle and take out the wheel.
D1-1—Main Brush Cover
D1-2—Main Brush Cover Latches
D1-3—Main Brush
D1-4—Main Brush Caps
D1-5—Main Brush Bearing
The omnidirectional wheel bracket cannot be removed.
Note:
D6-2—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
D1-6—Turn over the robot and press the
main brush latches to remove the
main brush cover.
Do not touch the surface of the filter with your
hands, brush, or hard objects to avoid potential damage.
Note:
D3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
D6-3—Allow at least 24 hours for the filter
to dry thoroughly and reinstall it.
D4 Main Wheel
D7 Mop Cloths
* Clean as required.
* Clean as required and replace every 1-3 months.
Clean the main wheel with a soft, dry cloth.
D1-7—Pull out the main brush and remove
the main brush bearing. Rotate the
main brush caps in the indicated
unlock direction to remove the caps,
and remove any entangled hair or
dirt at both ends of the main brush.
D1-8—Reinstall the main brush.
D7-1—Remove the mop cloth from the mop
cloth mount. Clean the mop cloth and
air-dry it.
39