Текст страницы
D8 VibraRise Mop Cloth
* Clean as required and replace every 3-6 months.
D5-2—Pinch the dustbin lid latch to open it
and remove the washable filter, then
empty the dustbin.
Notes:
• It is recommended to wipe the main brushes with a
wet cloth. If the main brushes are wet, air-dry them
away from direct sunlight.
• Do not use corrosive cleaning fluid or disinfectant to
clean the main brushes.
D8-1—Remove the mop cloth from the mop
cloth mount. Clean the mop cloth
and air-dry it.
D2 Side Brush
A dirty mop cloth will affect the mopping
performance. Clean it before use.
Note:
* Clean monthly and replace every 3-6 months.
D5-3—Fill the dustbin with clean water,
reinstall the washable filter and
close the dustbin lid. Gently shake
the dustbin, and then pour out the
dirty water.
To prevent blockage, only use clean water without
any cleaning liquid.
Note:
D8-2—Slide the mop cloth in from the
opening of the attachment slot, and
then stick it flat in place.
Unscrew the side brush screw. Remove and
clean the side brush. Then, align the central
groove with the raised position on the robot
and tighten the screw to reinstall the side brush.
D9 Robot Sensors
D5-4—Allow at least 24 hours for the dustbin
and washable filter to dry thoroughly
before reinstalling them.
* Clean as required.
D3 Omnidirectional Wheel
* Clean as required.
D6 Washable Filter
Use a soft, dry cloth to wipe and clean all
sensors, including:
* Clean every 2 weeks and replace every 6-12 months.
D3-1—Use a tool, such as a small
screwdriver, to pry out the axle and
take out the wheel.
D6-1—Pinch the dustbin lid latch to open it
and remove the washable filter.
The omnidirectional wheel bracket cannot be
removed.
Note:
D6-2—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Do not touch the surface of the filter with hands,
brushes, or hard objects to avoid potential damage.
Note:
D9-1—Upward Sensor
D9-2—Dock Locator
D9-3—Reactive AI Obstacle Recognition
Sensor
D9-4—Wall Sensor
D9-5—Communication Sensor
D9-6—Cliff Sensors
D9-7—Carpet Sensor
D3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Air-dry, reinstall, and press the wheel
and axle back in place.
D6-3—Allow at least 24 hours for the filter to
dry thoroughly before reinstalling it.
D10 Charging Contacts
D4 Main Wheels
D7 Edgewise Mop Cloth
* Clean as required.
* Clean as required.
* Clean as required and replace every 3-6 months.
Clean the main wheels with a soft, dry cloth.
Use a soft, dry cloth to wipe the charging
contacts on the robot and the dock.
D5 Dustbin
D7-1—Unscrew the screw in the middle of
the mop cloth. Wash the mop cloth
and air-dry it.
D11 Moving the Dock
* Clean as required.
A dirty mop cloth will affect the mopping
performance. Clean it before use.
Note:
To move the dock, grip the power cord
storage slot on the back with one hand and
the inner side of the front board with the
D5-1—Remove the magnetic top cover of
the robot and pinch the dustbin
latch to take out the dustbin.
D7-2—Reinstall the mop cloth and tighten
the screw.
44