Текст страницы
Notes:
D13 Cleaning Tray Module
cloth mounts. Clean the mop cloths
and air-dry them.
* Clean as required.
D13-1—
Remove the cleaning tray module.
• To avoid deformation, only use cold water.
• If any water stains remain on the outside of the
water tank, wipe them with a soft, dry cloth before
reinstalling the tank.
A dirty mop cloth will affect the mopping
performance. Clean it before use.
Note:
D13-2—
D7-2—
D11 Charging Contacts
Stick the mop cloths on the mounts
flat in place.
Remove the cleaning tray and filter
from the module and then rinse
them with water.
* Clean as required.
D13-3—
D8 Robot Sensors
Use a soft, dry cloth to wipe the charging
contacts on the robot and the dock.
* Clean as required.
Reinstall the filter and cleaning tray.
Then, reinstall the cleaning tray
module.
D12 Replacing Disposable Dust Bag
Use a soft, dry cloth to wipe and clean all
sensors, including:
* Replace as required.
Remove the dust container cover.
D12-1—
Note:
To prevent the dust container cover from falling
and hitting the robot, remove the cover with both
hands, one on each side.
D12-2—
Remove the disposable dust bag
and discard it.
D8-1—Upper Surface Sensor
D8-2—Front Navigation Sensor
D8-3—Wall Sensor
D8-4—Communication Sensor
D8-5—Rear Navigation Sensor
D8-6—Cliff Sensors
D8-7—Carpet Sensor
Notes:
D9 Moving the Dock
• The dust bag handle seals the bag on removal to
prevent leakage.
• Always install a dust bag before putting back the dust
container cover to avoid auto-emptying without the
bag. You can also disable auto-emptying in the app.
D12-3—
To move the dock, grip the power cord
storage slot on the back with one hand
and the inner side of the front board with
the other hand. Do not lift the dock base,
water tank handles, or dust container cover
directly to prevent the dock from falling off.
Clean the filter with a dry cloth,
insert a new disposable dust bag
into the slot all the way in, and
spread it evenly.
Note:
D10 Dirty Water Tank
* Clean as required.
Make sure the disposable dust bag is properly
installed to avoid waste escaping and damaging the
dock.
D12-4—
Reinstall the dust container cover
in place to make sure the dust
container is securely sealed.
Open the dirty water tank lid and pour
out the dirty water. Fill the tank with clean
water, close the lid, lock the latch, and
shake. Pour out the dirty water. Lock the lid
and reinstall the tank.
49