Текст страницы
Mop Washing
stop drying, tap the corresponding button
in the app.
gripper, and then close its gripper while
retracting to its compartment to complete
the reset action.
Notes:
Note:
- Drying duration can be modified in the app.
- Auto-drying can be disabled in the app.
- Stay away from the drying air outlets during drying.
If the robotic arm does not perform the reset
action for more than 10 minutes upon entering the
emergency stop status, it will automatically reset and
the robot will go to sleep.
Charging
Sleep
During cleaning, the robot automatically
determines when it should return to
the dock for mop washing and water
tank refilling to maximize its mopping
performance. To manually start washing,
tap the corresponding button in the app.
Press any button to stop washing.
Notes:
If the robot is paused for over 10 minutes,
it will go to sleep, and the power indicator
light will flash every few seconds. Press the
After cleaning, the robot will automatically
return to the dock to charge. Press to
send the paused robot back to the dock.
The power indicator light will breathe
during robot charging.
or button to wake the robot up.
Note:
• To ensure the robot automatically washes the mop
cloths, start it from the dock and avoid moving the
dock during cleaning.
• To avoid burns from hot water, do not touch the clean
water dispensers.
• Mop wash frequency and mode can be modified in
the app.
If the robot fails to find the dock, it will
automatically return to its starting position. Place the
robot on the dock manually to recharge.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left sleep for
more than 12 hours.
Emptying
Error
DND Mode
If an error occurs, the power indicator light
will flash red or status indicator light will be
steady red. A pop-up notification will appear
in the app and a voice alert may sound.
Notes:
After cleaning, the robot will return to
the dock and auto-emptying will begin
as needed. To manually start emptying,
press on the docked robot or tap the
corresponding button in the app. Press any
button to stop emptying.
Notes:
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period, or set whether to enable auto top-
up, emptying and drying, to dim indicator
lights, or lower the volume of the voice
message during the DND period.
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
Resetting the System
Child Lock
• When emptying has been left unused for a long
period, empty the dustbin manually and make sure
the air inlet is clear for optimal emptying performance.
• Auto-emptying can be disabled in the app.
• Avoid frequent manual emptying.
• Do not use without dustbin, dust container cover, or
disposable dust bag installed in place.
Drying
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system by removing the magnetic
top cover and pressing the Reset button.
Note:
Press and hold the
and buttons to
enable or disable Child Lock. You can also
set it in the app. Once enabled, the robot
will not react to button presses when it is
stationary.
After mop washing or after cleaning, drying
will begin as needed. To manually start or
After resetting the system, existing settings such
as scheduled cleaning and WiFi will be restored to
factory settings.
47