Текст страницы
MAINTENANCE
Pass the blade cap through the blade until the hook
catches the base cover. Note the direction of the blade
cap when attaching; the wider hook comes front side.
When removing the blade cap, lift it while pinching the
both sides.
► Fig.15: 1. Blade cap 2. Hook
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
During operation, insert the blade cap to the hook on
the base as illustrated until it clicks.
► Fig.16: 1. Blade cap 2. Hook
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Hex wrench storage
Cleaning the base cover
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► Fig.17: 1. Hex wrench
Connecting a vacuum cleaner
Clean off the cutting chips and dust accumlated on the
base cover. Lift the base cover while pulling the hook on
the back end to remove. Follow the removal procedure
in reverse when installing.
► Fig.22: 1. Base cover 2. Hook
CAUTION: Pay attention to the tip of the blade
and cutting chips when removing the base cover.
Connect a Makita vacuum cleaner for clean operation.
Remove the rubber cap on the dust collector and con-
nect the vacuum cleaner's hose to the nozzle of the
dust collector.
► Fig.18: 1. Dust collector 2. Rubber cap 3. Vacuum
cleaner hose
NOTICE: Perform the cleaning periodically. Dirty
base cover may damage or deface the working
surface.
OPERATION
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
CAUTION: Hold the tool firmly.
CAUTION: Always hold the base flush with
the workpiece during cutting. Never perform a
curved cut. Failure to do so may cause blade break-
age, resulting in a serious injury.
OPTIONAL ACCESSORIES
The V-notch and convexed portion in the base cover of
the tool indicate the position of the blade. Always check
the blade position when cutting.
The base cover of the tool
► Fig.19: 1. V-notch 2. Convexed portion 3. Blade
CAUTION: These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
NOTE: For accurate cutting, it is recommended to
draw cutting lines on the workpiece beforehand.
1.
Place the tip of the blade on the start line. Tilt the
tool so that the front edge of the base touches the work-
piece. Align the bottom of the V-notch in the front edge
with the cutting line.
► Fig.20
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
•
Drywall saw blade
•
Wood saw blade
•
Dust box
•
Dust collector
•
Hex wrench
•
Hook
•
Makita genuine battery and charger
2.
Slowly pull the trigger without the blade making
any contact with the workpiece. When the blade attains
full speed, push the tool toward the workpiece. As the
blade pierces the workpiece, make the whole surface of
the base cover contact with the workpiece.
► Fig.21
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
3.
Move the tool straight forward until the cutting
finishes.
9
ENGLISH