Текст страницы
AUTOMATIC WASHING MACHINE
WATER DRAIN FILTER CLEANING
ATTENTION! To avoid getting burned, wait until the water left in the washing
machine cools down! The water tap must be turned off!
Clean the water drain and fill filter every 6 months:
1
2
3
4
1. Shut off the tap so that no more water flows in and has to be drained. Switch the
appliance off. Unplug the power plug.
2. Open the drain filter cover.
3. Use the pull-out drain hose located in the pump access opening to drain the remaining
water into a suitable container (up to 5.3U.S.gallon/20 liters of water may be drained).
Pull the sealing cap from the hose and lay the hose over the side of the container and
allow the water to finish draining from the drum. When finished, replace the sealing
cap into the end of the hose and restore the hose to its storage location.
4. Turn the pump cover counterclockwise to remove it. A small amount of residual water
may flow out when the cover is removed. Clean the interior of the pump hosing,
removing any debris or foreign objects. Check to be sure the impeller where at the
back of the pump housing can now turn freely. Remove any lint, debris or detergent
residue from the threads of the pump cover and the pump cover housing. Replace
the pump cover by screwing tightly into position. Handle must be vertically.
5. Close the drain filter cover. Wipe up any spilled water. .
WATER SUPPLY FILTERS CLEANING
1
2
3
4
• Turn off the tap, disconnect the hose from the tap,
and clean the filter screen with a small brush.
• Disconnect the water supply hose from the washing
machine, pull out the filter screen with pliers, and
install it back after cleaning.
• Connect the filling hose, open the tap, and make sure
there is no water leakage.
40
USER GUIDE