Текст страницы
AUTOMATIC WASHING MACHINE
Timer may stop during water
intake
Timer indicator will not countdown until the
machine takes in adequate amount of water.
The machine will wait until there is sufficient
amount of water to avoid poor washing results
due to lack of water. Timer indicator will resume
countdown after this.
Programme time does
not countdown.
Timer may stop during
heating step.
Timer indicator will not countdown until the
machine reaches the selected temperature.
Timer may stop during
spinning step.
Automatic unbalanced load detection system
might be activated due to the unbalanced
distribution of the laundry in the drum.
Use recommended amount of detergent
Laundry remains
wet at the end of the
programme
Excessive foam might have
occurred and automatic foam
absorption system might
have been activated due to
too much detergent usage.
ATTENTION! Troubleshooting that is not spelled out in this manual can only
be carried out by a qualified specialist.
In case of malfunctions that are not specified in this manual, you should immediately
contact an authorized service center, specifying the type of problem and the model of
your washing machine. Only original spare parts can be used for repairs. Unqualified
repair removes the device from warranty service.
SELF-DIAGNOSIS
The washing machine has an internal diagnostic system, which, in caseof minor mal-
functions associated with improper operation, helps to determine their causes.
Fault codes
Fault type
Solutions
Reset the appliance with the Start / Stop - button
Check if the appliance
is overloaded or if the
laundry is caught in
the drum. After the
appliance has been
switched off and cooled
down for a while, it can
be switched on again.
Wait until the appliance
has cooled down.
E 1
Тhe connection of the
cable harness must
be checked. The plug
contacts must be
checked. The wiring
harness may need to be
replaced.
Switch off the appliance, close the water tap and disconnect the
appliance from the mains (unplug).
Please contact the aftersales service! These causes / measures
must be remedied or carried out by the aftersales service only!
The motor is defective
and must be replaced.
42
USER GUIDE