Текст страницы
Setting the device
Clean
Temperature
Heating
Setting Temperature
water circulation
Setting time
Installation
∙∙The appliance is suitable only for heating water, everything else blocks the pump.
∙∙Safely install the device.
∙∙Pay attention, that the water together with the food reaches the marking “max”.
∙∙Plug in the device.
∙∙If the water level is “min”, E01 appears on the display and the device beeps three
times.
Water quantity
Do not put too much water in the device - leave sufficient room for the food. If neces-
sary, top up water until Max. The unit can be switched on only when the water level
reaches the max marking. The food must always be covered with water. The tempe-
rature sensor needs a couple of minutes until he adjusted to the set temperature if
pre-heated water is filled in.
If there is no water in the pot, the device will not turn on and beeps E01.
Turn off the appliance, add water and start again.
The water level sensor switches off the appliance when the water level drops
rapidly
The last setting is shown on the display:
35,7
water temperature
57,4
set temperature
3:01
set time
At first start the set production values appear, they are insignificant.
16