Текст страницы
DRYER MACHINE
- Well-dry the filter net before storing it.
- Close the kick plate cover
DRAINING THE WATER TANK
Dampness of the laundry is removed and condensed during drying process and the
water that arise accumulates in the water tank. Drain the water tank after each drying
cycle.
To drain the water tank:
1. Remove the water tank in the drawer or
container carefully.
2. Drain the water in the tank
3. Place the water tank into its seat.
TROUBLESHOOTING
During operation, if faults are detected, which the consumer cannot eliminate it on
his own, it is necessary to contact the service center for the repair of washing machines.
But before contacting a repair service, read this section. This list includes the most
common cases that are not are the result of poor build quality or substandard materials,
used in this instrument.
ATTENTION! Disconnect the product from the mains before troubleshooting.
Troubleshooting not shown in this manual, should only be carried out by a qualified
electrician or competent person.
Malfunction
Possible reason
Remedy
The drying process is
taking too long.
Clogged internal or external filter
Rinse filters with warm water and dry
A lime layer may have accumulated
on the surface of the sensor
Clean the humidity sensor
A program not suitable for the type of
laundry has been started.
Too much laundry loaded
Do not overload the dryer
After the drying cycle,
the clothes remain
unchanged
Check the labels on the clothes and choose
the right program for the specific type of
clothes.
Dryer does not turn on
The power plug can be disconnected Make sure the power cord is connected
The selected program is
not being used
Loading door can be opened
Make sure the door is properly closed.
Make sure the program is installed and the
pause is not enabled.
Make sure child lock is disabled
There may have been a power
outage or failure.
Press Start/Pause to restart the program.
Consumption program
ahead of schedule.
The water tank may be full.
Drain the water from the water tank.
Water dripping from the
loading port
Dust, sand, wool could accumulate
on the sealing gum of the door
Clean the door seal
The water tank indicator
is flashing
The water tank is full.
Drain the water from the water tank.
The water drain hose may have
broken.
Check the integrity of the water drain hose.
25
user guide