Текст страницы
10
EN
• To select the keep warm temperature, press the
«Select С°» button (19), you can select the temperature
for maintaining hot water «98-85-65» degrees, the set
temperature is displayed with light indicators (16).
• Recommended water temperature for brewing tea and
making other beverages:
• Install the lid (5) to its place; to do this, set the lid (5) at
the angle of approximately 45° and insert the lid (5) to
its installation place; before using the thermopot make
sure that the lid (5) is fixed properly.
• Clean the outer surface of the thermopot body (9) with a
slightly damp cloth and then wipe it dry.
• Use neutral detergents to remove dirt, do not use metal
brushes, abrasives and solvents.
• Do not immerse the thermopot and the power cord (12)
into water or other liquids.
• Do not put the thermopot in a dishwashing machine.
Stains on the inner surface of the thermopot flask
-
«65» - red or herbal tea
-
«85» - green or yellow tea, brewing coffee
-
«95» - black tea
• If the water temperature drops significantly below the
set temperature, for example, if you added cold water,
in this case the boiling mode will switch on and the
indicator (21) «Boil» will light up.
• You can switch the water reboiling mode on by pressing
the button (20) «Reboil», the indicator (13) «Boil» will
light up, after boiling the water, the keep warm mode
will switch on and the keep warm indicator (15) will light
up.
• To switch the thermopot off disconnect the power cord
(14) plug from the mains socket.
CLEANING AND MAINTENANCE
• Water contains various minerals that can cause stains
on the inner surface of the thermopot flask, the stains
do not affect the operation of the thermopot, stains are
not covered by the warranty.
• You can remove the stains from the inner surface of the
thermopot flask with citric acid solution or table vinegar.
• To remove the flavour of citric acid or vinegar, boil water
and pour it out.
• Repeat this procedure until the smell and foreign taste
vanish completely.
Removing the mineral deposits (descaling)
• Scale, appearing inside the thermopot flask, influences
the water taste and disturbs the heat exchange between
water and the heating element. It also risks damaging
the heating element. Burning of the heating element
caused by the large amount of scale in the thermopot
flask is not covered by warranty.
• Before cleaning the thermopot unplug it (12), open
the lid (5) and wait until the thermopot cools down
completely.
• Always drain the remaining water from the thermopot
flask, to do this remove the lid (5).
• Before removing the lid (5) slightly open it at the angle
of approximately 45°, and pull the lid (5) towards the
control panel (4).
• Carefully tilt the thermopot to drain the remaining water.