Текст страницы
9
EN
Notes:
-
the thermopxnd boiling of water, the time depends
on the place where the thermopot is used, relative to
the height above sea level.
-
water heating and boiling time depends on the place
where the thermopot is used, relative to the height
above sea level.
• To avoid burns by hot steam, do not bend over the
steam release openings (7) in the thermopot lid (5).
Do not block the steam release openings (7) with any
objects.
• Drain the water after the first boiling. Hot water resulting
from the first boiling is not recommended to consume,
you may use it for domestic needs.
ATTENTION! Be careful when pouring out water to
avoid burns by hot water.
not performed any actions, the indicator (17) will
go out;
-
if you haven’t used the thermopot for a long time,
the water dispense may malfunction. In this case it
is recommended to open and close the lid (5) and
to switch the water dispense on again.
• To switch the thermopot off disconnect the power
cord (14) plug from the mains socket.
• Open the thermopot lid (5) and wait until it cools
down completely.
• Always drain the remaining water from the thermopot
flask, to do this remove the lid (5).
• Before removing the lid (5) slightly open it at the
angle of approximately 45°, and pull the lid (5)
towards the control panel (4).
• Carefully tilt the thermopot to drain the remaining
water.
• Install the lid (5) to its place; to do this, set the lid
(5) at the angle of approximately 45° and insert
the lid (5) to its installation place; before using the
thermopot make sure that the lid (5) is fixed properly.
• «Unlock» for 5 seconds, the indicator (17) will light up.
• To drain the water you can do the following:
First option: place a suitable bowl, for instance, a cup
under the spout for pouring water (3) and press the water
(2) dispense button with a rim of the cup (pic. 3).
Additional information
• Check the water level in the thermopot using the
scale (1).
• Timely refill the thermopot.
Second option: place a suitable dish under the water
spout (3), press and hold the any water supply button (14)
“Water supply”, after filling the cup, release the button (14)
(pic. 4).
HOT WATER MAINTENANCE TEMPERATURE
SELECTION
Notes:
• You can choose from six preset hot water
temperature maintenance settings.
-
water is supplied only when the indicator (17) is on,
if you have pressed the “Lock” button (18) and have