Текст страницы
PARTS DESCRIPTION
► Fig.4
3
Caution lamp
4
Main power button
1
Speed indicator
2
ADT indicator
(ADT = Automatic Torque
Drive Technology)
5
Reverse button
6
Battery cartridge
7
Lock-off lever
8
Switch trigger
9
Hanger
10
Handle
11
Barrier (country specific)
12
Protector
16
Shoulder harness
15
Cap
(DUR191U and
DUR191L only)
14
Joint cover
(DUR191U and
DUR191L only)
13
Lock lever
(DUR191U and
DUR191L only)
Tool / battery protection system
FUNCTIONAL DESCRIPTION
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to
the motor to extend tool and battery life. The tool will
automatically stop during operation if the tool is placed
under one of the following conditions:
Caution lamp
Status
Color
On
Blinking
WARNING: Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Failure to switch off and remove the battery cartridge
may result in serious personal injury from accidental
start-up.
Red
Overload
Red
Overheat
Installing or removing battery
cartridge
Red
Over
discharge
Overload protection
CAUTION: Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION: Hold the tool and the battery car-
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
► Fig.5: 1. Red indicator 2. Button 3. Battery cartridge
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
If the tool gets into one of the following situation, the tool auto-
matically stops and the caution lamp starts blinking in red:
—
The tool is overloaded by entangled weeds or
other debris.
—
The cutting tool is locked or kicked back.
—
The main power button is turned on while the
switch trigger is being pulled.
In this situation, release the switch trigger and remove
entangled weeds or debris if necessary. After that, pull
the switch trigger again to resume.
CAUTION: If you need to remove the entan-
gled weeds on the tool or release the locked
cutting tool, be sure to turn the tool off before you
start.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
Overheat protection for tool or battery
CAUTION: Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
If the tool or battery cartridge is overheated, the tool
stops automatically. When the tool or battery cartridge is
overheated, the speed indicator and ADT indicator go off
and the caution lamp lights up in red. Let the tool and/or
battery cool down before turning the tool on again.
CAUTION: Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
Overdischarge protection
When the battery capacity becomes low, the tool stops
automatically. The speed indicator and ADT indicator go
off and the caution lamp starts blinking in red.
If the tool does not operate even when the switches are
operated, remove the battery cartridge from the tool and
charge it.
18
ENGLISH