Текст страницы
Overdischarge protection
Speed adjusting
When the battery capacity becomes low, the tool stops
automatically and the caution lamp starts blinking in red.
If the tool does not operate even when the switches are
operated, remove the battery cartridge from the tool and
charge it.
You can select the tool speed by tapping the main
power button. Each time you tap the main power button,
the level of speed will change. The tool automatically
adjusts the rotation speed according to the cutting tool
attached to the tool.
► Fig.8: 1. Speed indicator 2. Main power button
Main power switch
Speed
indicator
Mode
Rotation speed
Cutter blade
Plastic blade
(305 mm)
Tap the main power button to turn on the tool.
To turn off the tool, press and hold the main power
button until the speed indicator goes off.
► Fig.5: 1. Speed indicator 2. Main power button
Nylon cutting
head
Plastic blade
(255 mm)
NOTE: The tool will automatically turned off if it is left
without any operations for a certain period of time.
High
0 - 7,000
min
-1
0 - 5,500
min
-1
Switch action
Medium
0 - 5,500
min
-1
0 - 5,000
min
-1
Low
0 - 4,600
min
-1
0 - 4,600
min
-1
WARNING: For your safety, this tool is
equipped with lock-off lever which prevents the
tool from unintended starting. NEVER use the tool
if it runs when you simply pull the switch trigger
without pressing the lock-off lever. Return the
tool to our authorized service center for proper
repairs BEFORE further usage.
WARNING: NEVER tape down or defeat pur-
pose and function of lock-off lever.
Automatic Torque Drive Technology
CAUTION: Before connecting the portable
power pack to the tool, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released. Operating a
tool with a switch that does not actuate properly can
lead to loss of control and serious personal injury.
When you turn on the Automatic Torque Drive
Technology (ADT), the tool runs at optimum rotation
speed and torque for the condition of grass being cut.
The tool automatically detects the cutting tool attached
and chooses a suitable rotation speed.
CAUTION: Never put your finger on the main
power button and switch trigger when carrying
the tool. The tool may start unintentionally and cause
injury.
To start ADT, press and hold the reverse button until the
ADT indicator turns on.
To stop ADT, press and hold the reverse button until the
ADT indicator turns off.
► Fig.9: 1. ADT indicator 2. Reverse button
NOTICE: Do not pull the switch trigger hard with-
out pressing the lock-off lever. This can cause
switch breakage.
Indicator
Mode
Cutting tool
Rotation
speed
3,500 - 7,000
min
-1
ADT
Cutter blade
Plastic blade
(305 mm)
3,500 - 5,500
min
-1
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
depress the lock-off lever and pull the switch trigger.
The tool speed increases by increasing pressure on the
switch trigger. Release the switch trigger to stop.
Nylon cutting
head
Plastic blade
(255 mm)
UR101C
► Fig.6: 1. Lock-off lever 2. Switch trigger
Reverse button for debris removal
UR201C
► Fig.7: 1. Lock-off lever 2. Switch trigger
WARNING: Switch off the tool and disconnect
the portable power pack from the tool before you
remove entangled weeds or debris which the
reverse rotation function can not remove. Failure
to do so may result in serious personal injury from
accidental start-up.
This tool has a reverse button to change the direction of
rotation. It is only for removing weeds and debris entan-
gled in the tool.
25
ENGLISH