Текст страницы
Installing the handle
For UR101C
1.
Insert the shaft of the handle into the grip. Align
the screw hole in the grip with the one in the shaft.
Tighten the screw securely.
► Fig.11: 1. Grip 2. Screw 3. Shaft
To reverse the rotation, tap the reverse button and pull
the switch trigger while depressing the lock-off lever
when the cutting tool is stopped. The speed indicators
and ADT indicator start blinking, and the cutting tool
rotates in reverse direction when you pull the switch
trigger.
To return to regular rotation, release the trigger and wait
until the cutting tool stops.
► Fig.10: 1. Speed indicator 2. ADT indicator
3. Reverse button
NOTICE: Note the direction of the grip. The
screw holes will not be aligned if the grip is not
inserted in the correct direction.
NOTE: During the reverse rotation, the tool operates
only for a short period of time and then automatically
stops.
2.
Place the spring onto the base.
► Fig.12: 1. Knob 2. Handle clamp 3. Handle
4. Handle holder 5. Spring 6. Base
NOTE: Once the tool is stopped, the rotation returns
to regular direction when you start the tool again.
3.
Place the handle between the handle clamp and
handle holder.
NOTE: If you tap the reverse button while the cutting
tool is still rotating, the tool comes to stop and to be
ready for reverse rotation.
4.
Temporarily attach the handle by tightening the
knob, and adjust the handle position.
5.
Fully tighten the knob.
Electric brake
For UR201C
1.
Attach the upper and lower clamps on the damper.
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at our service center.
2.
Put the handle on the upper clamp and fix it with
hex socket head bolts as illustrated.
► Fig.13: 1. Hex socket head bolt 2. Handle 3. Upper
clamp 4. Damper 5. Lower clamp
CAUTION: This brake system is not a substi-
tute for the protector. Never use the tool without
the protector. An unguarded cutting tool may result
in serious personal injury.
Attaching the barrier
Electronic function
For the loop handle model only (country specific)
Constant speed control
If the barrier is included in your model, attach it to the
handle using the screw on the barrier.
► Fig.14: 1. Barrier 2. Screw
The speed control function provides the constant rota-
tion speed regardless of load conditions.
Soft start feature
CAUTION: After assembling the barrier, do
not remove it. The barrier works as a safety part
to prevent you from contacting the cutting blade
accidentally.
Soft start because of suppressed starting shock.
Hex wrench storage
ASSEMBLY
CAUTION: Be careful not to leave the hex
wrench inserted in the tool head. It may cause
injury and/or damage to the tool.
When not in use, store the hex wrench as illustrated to
keep it from being lost.
► Fig.15: 1. Hex wrench
WARNING: Always be sure that the tool is
switched off and the portable power pack is dis-
connected from the tool before carrying out any
work on the tool. Failure to switch off and disconnect
the portable power pack may result in serious per-
sonal injury from accidental start-up.
For the bike handle model, the hex wrench can be
stored on the handle clamp as illustrated.
► Fig.16: 1. Hex wrench 2. Handle clamp
WARNING: Never start the tool unless it is
completely assembled. Operation of the tool in a
partially assembled state may result in serious per-
sonal injury from accidental start-up.
For the loop handle model, the hex wrench can be
stored on the handle as illustrated.
► Fig.17: 1. Hex wrench
26
ENGLISH