Текст страницы
plosion. Penetrating a water line causes property dam-
age or may cause an electric shock.
rotating wheel. When the wheel, at the point of opera-
tion, is moving away from your body, the possible kick-
back may propel the spinning wheel and the power tool
directly at you.
• Release the On/Off switch and set it to the off position
when the power supply is interrupted, e. g. , in case of
a power failure or when the mains plug is pulled. This
prevents uncontrolled restarting.
• Do not touch grinding and cutting discs before they
have cooled down. The discs can become very hot while
working.
• When wheel is binding or when interrupting a cut for
any reason, switch off the power tool and hold the pow-
er tool motionless until the wheel comes to a complete
stop. Never attempt to remove the cut-off wheel from
the cut while the wheel is in motion otherwise kickback
may occur. Investigate and take corrective action to
eliminate the cause of wheel binding.
• Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than
by hand.
• Do not restart the cutting operation in the workpiece.
Let the wheel reach full speed and carefully re-enter the
cut. The wheel may bind, walk up or kickback if the pow-
er tool is restarted in the workpiece.
MAINTENANCE AND CLEANING
Make sure that the machine is not live when carry-
ing out maintenance work on the motor.
• Support panels or any oversized workpiece to minimize
the risk of wheel pinching and kickback. Large work-
pieces tend to sag under their own weight. Supports
must be placed under the workpiece near the line of
cut and near the edge of the workpiece on both sides
of the wheel.
• Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots free
from dust and dirt. If the dirt does not come off use a soft
cloth moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water, etc. These sol-
vents may damage the plastic parts.
• Use extra caution when making a “pocket cut” into ex-
isting walls or other blind areas. The protruding wheel
may cut gas or water pipes, electrical wiring or objects
that can cause kickback.
• The machine requires no additional lubrication.
Safety warnings specific for sanding operations
DISPOSAL
• Do not use excessively oversized sanding disc paper.
Follow manufacturers recommendations, when select-
ing sanding paper. Larger sanding paper extending be-
yond the sanding pad presents a laceration hazard and
may cause snagging, tearing of the disc, or kickback.
Discarded electric appliances are recyclable
and should not be discarded in the domestic
waste! Please actively support us in conserving
resources and protecting the environment by
returning this appliance to the collection centres (if
available).
Made in China.
Safety warnings specific for wire brushing
operations
• Be aware that wire bristles are thrown by the brush even
during ordinary operation. Do not overstress the wires
by applying excessive load to the brush. The wire bris-
tles can easily penetrate light clothing and/or skin.
• If the use of a guard is recommended for wire brushing,
do not allow any interference of the wire wheel or brush
with the guard. Wire wheel or brush may expand in di-
ameter due to work load and centrifugal forces.
Additional safety warnings
• Wear safety goggles.
• Use suitable detectors to determine if utility lines are
hidden in the work area or call the local utility company
for assistance. Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can lead to ex-
15