Текст страницы
Operation Instructions
WARNING: Read the manual carefully before operation
Lever switch
1
The switch "I" corresponds to On, and "O" corresponds to OFF. To start the tool, move the switch to the ''I'' (on)
position. To stop, move the switch to the ''O'' (off) position.
CAUTION: Before plugging in the tool, always be sure that the toggle switch is moved to the "O" position.
Shaft lock
2
The shaft lock is used to prevent spindle rotation when
installing or removing accessories such as grinding wheel. Never actuate the shaft lock when the spindle is
moving.
Installing grinding wheel
3
First, mount the inner flange onto the spindle so that the recess on the inner flange fits onto the two parallel
flat faces on the spindle. After placing the grinding wheel on the inner flange, screw the outer flange onto
the spindle. Press the shaft lock and turn the grinding wheel at the same time until the spindle is locked. At
the same time, use the lock nut wrench attached with the machine to tighten the outer flange plate to fix the
grinding wheel. Insert into the outer flange hole by aligning with the two protruding points on the wrench
and tighten the outer flange plate. After installation, turn the grinding wheel and check whether it is locked.
Run it for about 30 seconds without load to ensure that the grinding wheel will not shake too much or fall
off. To remove the wheel, follow the installation procedure in reverse.
EN
8