Текст страницы
16.Do not operate the power tool near
Additional safety instructions for grinding
and cutting-off operations
flammable materials. Sparks could ignite
these materials.
17. Do not use accessories that require
Safety warnings specific for grinding and
cutting-off operations:
1. Use only wheel types that are specified
liquid coolants. Using water or other liquid
coolants may result in electrocution or shock.
Further safety instructions for all
operations
for your power tool and the specific
guard designed for the selected wheel.
Wheels for which the power tool was not
designed cannot be adequately guarded and are
unsafe.
2. The grinding surface of centre
depressed wheels must be mounted
below the plane of the guard lip. An
improperly mounted wheel that projects through
the plane of the guard lip cannot be adequately
protected.
3. The guard must be securely attached
to the power tool and positioned for
maximum safety, so the least amount of
wheel is exposed towards the operator.
The guard helps to protect the operator from
broken wheel fragments, accidental contact
with wheel and sparks that could ignite
clothing.
4. Wheels must be used only for
Kickback and related warnings:
Kickback is a sudden reaction to a pinched or
snagged rotating wheel, backing pad, brush or any
ther accessory. Pinching or snagging causes rapid
stalling of the rotating accessory which in turn
causes the uncontrolled power tool to be forced in
the direction opposite of the accessory’s rotation at
the point of the binding.
For example, if an abrasive wheel is snagged or
pinched by the workpiece, the edge of the wheel
that is entering into the pinch point can dig into the
surface of the material causing the wheel to climb
out or kick out. The wheel may either jump toward
or away from the operator, depending on direction
of the wheel’s movement at the point of pinching.
Abrasive wheels may also break under these
conditions.
Kickback is the result of power tool misuse and/or
incorrect operating procedures or conditions and
can be avoided by taking proper precautions as
given below.
1. Maintain a firm grip with both hands
specified applications. For example:
do not grind with the side of cut-off
wheel. Abrasive cut-off wheels are intended
for peripheral grinding, side forces applied to
these wheels may cause them to shatter.
5. Always use undamaged wheel flanges
that are of correct size and shape
for your selected wheel. Proper wheel
flanges support the wheel thus reducing the
possibility of wheel breakage. Flanges for
cut-off wheels may be different from grinding
wheel flanges.
6. Do not use worn down wheels from
on the power tool and position your
body and arms to allow you to resist
kickback forces. Always use auxiliary
handle, if provided, for maximum
control over kickback or torque reaction
during start-up. The operator can control
torque reactions or kickback forces, if proper
precautions are taken.
2. Never place your hand near the rotating
accessory. Accessory may kickback over your
hand.
3. Do not position your body in the area
larger power tools. A wheel intended for
larger power tool is not suitable for the higher
speed of a smaller tool and may burst.
7. When using dual purpose wheels
where power tool will move if kickback
occurs. Kickback will propel the tool in direction
opposite to the wheel’s movement at the point of
snagging.
4. Use special care when working corners,
always use the correct guard for the
application being performed. Failure
to use the correct guard may not provide the
desired level of guarding, which could lead to
serious injury.
sharp edges, etc. Avoid bouncing and
snagging the accessory. Corners, sharp
edges or bouncing have a tendency to snag the
rotating accessory and cause loss of control or
kickback.
5. Do not attach a saw chain woodcarving
blade, segmented diamond wheel with
a peripheral gap greater than 10mm
or toothed saw blade. Such blades create
frequent kickback and loss of control.
EN
6