Текст страницы
OPERATION
MAINTENANCE
Abrasive cutting: Never use roughing discs for cutting!
■ Use only tested fibre-reinforced cutting or grinding discs that are
approved for a circumferential speed of not less than 80 m/s.
CAUTION! The grinder continues running after being turned off. Do not try to brake it
by applying lateral counterpressure.
■ Secure the workpiece. Use clamps/a vice to hold the workpiece firmly in place. This
is much safer than simply holding it in your hand.
■ Always switch off the appliance before putting it down and wait for the appliance to
come to a complete standstill.
■ Use the appliance only for dry cutting or sanding.
■ The additional handle must be mounted on the appliance for all work.
■ Materials containing asbestos may not be processed. Asbestos is a known
carcinogen.
Always wear safety goggles!
Always wear a dust mask!
Wear hearing protection!
MAINTENANCE
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they are properly tightened. Should any of the
screws be loose, retighten it immediately to avoid hazards.
If the replacement of the supply cord is necessary, this has to be done by the manufacturer
or his agent in order to avoid a safety hazard.
CLEANING
For safe operation always keep the machine and its ventilation slots clean.
Regularly check to see if any dust or foreign matter has entered the ventilation slots and the
grills around the switches. Use a soft brush and/or air jet to remove any accumulated dust.
Wear safety glasses to protect your eyes whilst cleaning.
Exterior plastic parts may be cleaned with a damp cloth and mild detergent if necessary.