Текст страницы
KNOW YOUR PRODUCT
A kickback is caused by improper or incorrect use of the power tool. This can be avoided by
taking proper precautions as given below.
a) Hold the power tool firmly in both hands and position your body and arms so they can
absorb the force of a kickback. Always use the additional handle, if available, so that
you have the maximum possible control over the kickback force or reaction forces at full
speed. By taking adequate precautions, the operator can stay in control of the kickback
and reaction torques.
b) Never hold your hand close to a rotating accessory tool. The accessory tool could hit
your hand in the event of a kickback.
c) Avoid having any part of your body in the region in which the power tool is likely to
move in event of a kickback. The kickback will force the power tool in the opposite
direction to the direction of rotation of the grinding disc at the blockage.
d) Take special care when working near corners, sharp edges, etc. Avoid allowing the
accessory tool to bounce back from the workpiece or jam. The rotating accessory tool is
more likely to jam in corners or sharp edges or if it rebounds off them. This can cause a loss
of control or kickback.
KNOW YOUR PRODUCT
4.
Blade guard
5.
Lock off button
1.
ON/OFF switch
2.
Spindle locking button
3.
Front handle
OPERATION
Switching ON/OFF
To turn your grinder on: Press the lock-off button forward (5). Depress the on/off switch
trigger (1).
To turn your grinder off: Release the on/off switch trigger (1).
MOUNTING THE WHEEL GUARD (Fig. 1)
Release the lever 4 on the grinding wheel guard 1. When installing the grinding wheel
cover, align the flange piece on the grinding wheel cover ring with the notch on the
bearing housing 2. Then rotate the grinding wheel cover to the position as shown on the
picture. Tighten the rod on the wheel cover to secire the wheel cover. if the rod is too tight
or loose to hold the wheel guard in place, use a wrench to loosen or tighten the nut 3 to
adjust the tightness of the wheel guard ring.
When removing the grinding wheel cover, proceed in the reverse order of the installation
steps.