Текст страницы
Access Point Mode (if supported)
LED Explanation
Status
LED
Indication (For Range Extender Mode)
If your extender has an Ethernet port, you can also set up it as an access
point to transform your existing wired network to a wireless one.
Off
Power is off.
For detailed instructions, please visit http://www.mercusys.com and go to
your extender’s support page to get its User Guide.
Blinking
The extender is starting, or
connecting to the host network.
Solid Red
The extender is not connected to
the host network.
Ethernet4
Ethernet3
Ethernet1Ethernet2
Internet
Ethernet
Solid Green
The extender is connected to the
host network and works well.
Wired Router
Extender
Devices
Signal
LED
Solid Orange
The extender is connected to the
host network, but is too far away
from the router.
FAQ (Frequently Asked Questions)
Q1. How do I reset the extender?
method on the front page to complete the configuration.
• Try setting up via the WPS button.
• Reset the extender and go through the setup again.
• With the extender powered on, press and hold the Reset or RESET/WPS
button until the Signal LED turns off, then release the button. When the
Signal LED turns solid on, the reset process is complete.
If you are still having problems, contact our technical support.
Q2. What should I do if I cannot access the extender’s web management
page?
For technical support, user manuals and more information,
please visit http://www.mercusys.com/support.
• Make sure your wireless device is connected to the extended network
using the extended SSID.
• Verify that http://mwlogin.net is correctly entered in the web browser.
Safety Information
• If you are using a computer, make sure it is set to obtain an IP address
automatically. Unplug the Ethernet cable if any.
• Use another web browser and try again.
• Refer to Q1 to reset the extender and try again.
Q3. What should I do if I forgot my login password of the web
management page?
• Refer to Q1 to reset the extender to its factory default settings, then
create a password to log in.
• Keep the device away from water, fire, humidity or hot environments.
• Do not attempt to disassemble, repair, or modify the device. If you need service, please
contact us.
• Do not use the device where wireless devices are not allowed.
• The socket-outlet shall be installed near the equipment and shall be easily accessible.
• For passthrough devices, plug the power strips into the integrated electrical
sockets of the devices, but devices of the same or another type not be stacked
in normal use. Do not plug in a row.
Please read and follow the above safety information when operating the device. We
cannot guarantee that no accidents or damage will occur due to improper use of the
device. Please use this product with care and operate at your own risk.
Q4. What should I do if the Signal LED doesn’t turn solid green or orange
after completing setup via a web browser?
• You may have entered incorrect Wi-Fi password(s) for your router during
the setup. Check the password(s) and try again.
• Make sure the extender is close to your router, preferably within 16 feet,
and away from large electrical appliances.
MERCUSYS hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/53/EU, 2009/125/EC,
2011/65/EU and (EU)2015/863.
The original EU declaration of conformity may be found at
https://www.mercusys.com/en/ce.
MERCUSYS hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of the Radio Equipment Regulations 2017.
The original UKCA declaration of conformity may be found at
https://www.mercusys.com/support/ukca/
• If you have enabled wireless MAC filtering, wireless access control, or
access control list (ACL) on your router, disable them first, then follow any