Текст страницы
Chapter 6
Use Your Extender as an Access Point
6. 3. LED Explanation for the Access Point Mode
When the extender works in the Access Point mode, you can check its working status
by following the LED Explanation table below.
Name
Status
Indication (For Access Point Mode)
On/Off
The extender is on or off.
(Power)
Blinking
The system is starting up or firmware is being upgraded.
On
A WPS connection is established.
Blinking
WPS connection is in progress. This may take up to 2 minutes.
(Signal)
Off
A WPS connection has been established for more than 5
minutes or WPS connection failed.
2.4G
On/Off
The 2.4 GHz wireless band is enabled or disabled.
5G
On/Off
The 5 GHz wireless band is enabled or disabled.
36