Инструкция утюг Centek CT-2308

STEAM STROKE
To use the steam shock function (powerful one-time steam emission), press the
«Steam Shock» button.

• COMPLETENESS
• Iron - 1 pc.
• Measuring cup - 1 pc.
• User manual - 1 pc.

ATTENTION! Use the «Steam blow» button only after the iron is heated to the
steam production temperature. Do not press the steam shock button more than
three times in a row.

THERMAL FUSE
If the iron’s thermostat fails, the appliance will automatically turn off to prevent
overheating. In this case, you should contact customer service.

4. WORKING PROCEDURE
Remove the protective film/cardboard from the sole of the iron. The steam iron
can use ordinary tap water. If the hardness of tap water exceeds 17° dH, it is
necessary to use distilled or demineralized (filtered) water to increase the service
life of the iron. Fill the water tank (for steam ironing). Disconnect the iron from
the mains and set the steam supply switch to the «0» position. Fill in the water
so that its level is visible approximately in the middle of the transparent part of
the iron body. Plug the iron into an electrical outlet.

6. Do not use the appliance if the power cable or plug is damaged.
7. Do not submerge the appliance in water.
8. Do not allow the power cable to contact the hot sole of the appliance.
9. Prior to putting the appliance away for storage let it cool down completely.
10. Use and store the appliance on a stable surface.
11. Do not operate the appliance if it has been dropped, has visible damage
or leaks water.
12. Do not connect the appliance to power supply via a timer or other remote
control device.
13. The surface of the heating element will remain hot for some time after the
appliance is turned off.
14. Accessible surfaces of the appliance can become very hot during operation.
15. Special instructions for transportation (shipment) and sale: none.
16. If you wish to transfer the device for use by another person, please transfer
it along with these instructions.

ANTI-DRIP FUNCTION
This system constantly controls the water supply to the sole. When a certain
temperature is reached, the anti-drip function shuts off the water supply and
prevents dripping from the iron onto the fabric.

ATTENTION! Before first use, try the iron out on a useless piece of fabric to ensure
that the sole or the water tank is not contaminated. Some parts of the appliance
are slightly lubricated during assembly; therefore some smoke can occur when
the iron is turned on for the first time. This should disappear within a few seconds.

TEMPERATURE CONTROL
Sort the laundry according to the composition of the fabrics and the appropriate
ironing temperature. Iron products that require a lower temperature first, since
the iron heats up faster than it cools down. The indicator lamp signals the heating
of the iron. Turning off the lamp indicates that the iron has reached the set
temperature and You can start ironing.

FUNCTIONS
SPRAYER
To spray water on the fabric, press the «Spray» button.

DRY IRONING/STEAM
To turn on the steam supply, move the steam supply switch to position
«
». To turn off steam (dry ironing), move the steam switch to position «0».

AUTOMATIC SHUTDOWN FUNCTION
- The iron will automatically shut down if it rests in a horizontal position for 30
seconds or in a vertical position for 8 minutes.
- When the automatic shutdown function trips the appliance will emit 6 audio
signals and the automatic shutdown indicator will start blinking.
- The iron can take 45 to 60 minutes to fully cool down.
- In order to heat up the iron again proceed as follows:
- Pick the iron up or move it around slightly.
- The automatic shutdown indicator will stop blinking.
- The automatic shutdown indicator will light continuously and the iron will
become ready for operation.

1. APPLIANCE DESCRIPTION
2. Sprayer
3. Filler neck
4. Steam switch
5. Spray button
6. Steam shock button
7. Mode controller
8. Ceramic-coated sole
9. Indicator

10