Текст страницы
ATTENTION! When ironing, water may flow through the sole of the iron. This
happens if the («МИН.» - «••») temperature is too low. If this happens, turn the
temperature control to the «••» position. Once the newly selected temperature
is reached, the water flow will decrease significantly. We draw your attention
to the fact that a slight flow of water through the sole of the iron is permissible
and is not a defect.
serial number (digits 2 and 3 - year, digits 4 and 5 - month of manufacture). If any
questions related to appliance maintenance should arise, or if the appliance has
malfunctions, apply to the CENTEK TM Authorized Service Center. The address of
the service center can be found on the website https://centek.ru/servis. Service
support contacts: Phone: +7 (988) 24-00-178, VK: vk.com/centek_krd. General
Service Center: OOO «Larina-Servis», Krasnodar, Phone: +7 (861) 991-05-42.
The product has the Certificate of Conformity No.:
ЕАЭС RU С-CN.АЖ49.В.03673/24 of 18.03.2024.
10. Shake the iron gently. Continue releasing steam and water until the water
tank is almost empty.
11. Connect the iron to the mains.
12. Set the temperature control to the «МАКС.» position, allow the iron to heat
up again, the remaining water inside the steam chamber will evaporate and
exit the iron through the soleplate.
13. Unplug the iron. Let cool completely. Wipe the soleplate of the iron with
a dry cloth.
During the dry steaming process, it is recommended to use it over an old piece
of cloth.
5. CARE OF THE DEVICE
Set the temperature controller to the OFF position and disconnect the iron from
the mains. Place the iron in an upright position and let it cool completely. Drain
the water from the iron container. Set the steam supply regulator to the «0»
position. Remove deposits from the sole of the iron with a solution of acetic acid.
Wipe the iron body with a damp cloth, then wipe dry.
9. INFORMATION ABOUT THE MANUFACTURER, IMPORTER
I mported to EAEU by: Individualniy Predprinimatel Asrumyan Karo
Shurikovich. Address: Russia, 350912 Krasnodar, ul. Atamana Lysenko, 23, pgt.
Pashkovskiy, phone: +7 (861) 2-600-900.
SELF CLEANING FUNCTION
- SPECIFICATIONS
- Nominal rated voltage: 220-240 V ~50/60 Hz
- Nominal power rating: 2350-2800 W
- Water tank: 320 ml
NOTE: Your iron will provide the best ironing results and last longer if you use
the self-cleaning function once a month or more often depending on usage.
CAREFUL: accessible surfaces of the appliance can reach high temperature during
operation. Do not touch the hot surfaces.
DEAR CONSUMER!
The guarantee period for all appliances amounts to 12 months from the date
of sale to the end consumer. With this Warranty Card the Manufacturer
confirms the proper condition of the appliance and undertakes to repair, free
of charge, all defects caused by the Manufacturer’s default.
7. DISPOSAL
Upon expiry of its service life the appliance can be disposed of separately from
ordinary domestic waste. You can turn it over to a specialized electric and
electronic appliance disposal and recycling centre.
GUARANTEE MAINTENANCE TERMS
1. The guarantee shall be valid if the following documentation conditions
are observed:
• The original Warranty Card shall be filled out correctly and clearly, indicating the
of appliance model, serial number and sale date, the stamp of the seller company
and signature of its representative shall be available, as well as the stamps on
each coupon and the buyer’s signature in the Warranty Card.
1. Fill the reservoir halfway with water.
2. Place the iron in a vertical position.
3. Set the mode dial to the «МАКС.» position.
4. Turn the steam adjustment knob to position «0».
5. Connect the iron to the mains.
6. Let the iron heat up until the light goes out.
7. Unplug the iron.
8. Hold the iron horizontally over the sink.
9. Take out the self-cleaning button as shown in the
picture. Boiling water and steam will now come
out of the holes in the sole.
8. CERTIFICATION DATA, GUARANTEE
The service life of this item is 5 years since the date of sale to the end user,
provided the item will be used in strict accordance with the present manual and
the applicable technical standards. Upon expiry of the service life please contact
the nearest authorized service centre for suggestions as to further operation
of the appliance. The manufacturing date of the appliance is integrated into the
11