Текст страницы
УТЮГ
IRON
temperature mode after ironing at a higher one, before the light indicator is turned on
again.
• Set the disc heating control to the minimum position.
• Pull the plug out of the socket.
• Place the iron in an upright position
Mark
Type of textile product
Forbidden to iron
•
Synthetic, nylon, acrylic, polyester, viscose
• •
Wool, silk
• • •
Cotton, linen
Mark
Temperature mode
Thermostat
•
Low temperature
•••
Middle temperature
••• max
High temperature
REFILLING WATER
- Turn off the iron before filling the water tank.
- Keep the iron in a horizontal position.
- Slowly pour water through the filling hole.
- Do not fill higher than the mark on the water tank.
- The water tank must be completely cleaned after each use.
ATTENTION! The steam iron is designed to use tap water, however, if the water
is very hard, it is recommended to dilute it with an equal amount of distilled water.
IMPORTANT! When draining the water after complete cooling, it is necessary
to install place the iron in the vertical position and turn the thermostat knob to
the maximum position and leave it on for two minutes. After this procedure, it is
necessary to disconnect the iron from the power supply network.
STEAM IRONING
- Set the temperature controller to the •• or ••• position.
- Set the steam regulator to the desired position.
ATTENTION! Avoid contact with steam during steaming.
16
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE