Текст страницы
УТЮГ
IRON
• After use, allow the hair dryer to cool down and store it in a cool, dry place out of the
reach of children;
• Wrap the cord around the heel of the iron.
• Handle the power cord carefully, try not to pull, twist or stretch it, especially near the
plug and at the place where the iron is inserted into the body. If the cord is twisted
during the use of the iron, straighten it periodically;
TROUBLESHOOTING
Problem
Possible Reasons
Measurement
Not enough heat or Too
heat
Rotate thermostat knob
improperly or unplugging
Correct thermostat knob
in position and check if the
iron is plugged.
No steam or Leakage
The thermostat knob has
been set to MIN
Set the thermostat knob to
the required positioin.
No surge of steam or no
vertical steam
Continue ironing in
horizontal position and wait
a while before using the
(vertical) burst of steam
function again
The(vertical) burst of
steam function has been
used too often within a very
short period. The iron is not
hot enough
Set the thermostat knob
out of steam range.
Установите ручку термо-
стата в соответствии с
диапазоном подачи пара
Leaking water from
Soleplate
The heat is still not enough. Set the thermostat knob as
per steam range.
The water is over than max
position
Pour out the remaining
water
Set the steam selector to
the proper location.
Check if the Steam
Selector is in proper
location.
Little Steam
Steam hole is blocked.
Clean hole with distilled
water.
Too little water in the water
tank
Fill water into the box
No Spraying
No enough pressure or air
inside
Press the spray nozzle
by hand, and push the
spray button several times
continuously.
18
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE