Текст страницы
very dry environment, we recommend that you operate the device on con-
tinuous operation (“CO”) and at least level 4 (humidification level) for the
first few days to allow the humidity to rise effectively.
Setting up / operation
1. Place Noah / Noah Pro in the desired location on a flat surface. Lift off
the upper part (3) from the device to fill the lower part (14) at the tap to
the maximum mark (18) with clean, cold tap water. Alternatively, you can
fill the lower part (14) with a clean watering can through the filling open-
ing (17) (see point 9). Caution: no water may enter the air outlet opening
(20)! If you filled the lower part directly from the tap, put the upper part
(3) back on the lower part (14), making sure that they fit together prop-
erly. Please note the labelling (“Front”) on the lower part. Connect the
power cable (1) to the power adapter connection (2) on the device first of
all and then to a socket with the correct voltage rating.
2. Start the appliance by pressing the On/Off button (5). The current rela-
tive humidity in % is shown on the display (12). If “NO” appears on the
display (12), there is not enough water in the unit. The humidification
output level is pre-set to level 2 and the desired humidity on continuous
operation “CO”.
3. The desired humidity can be changed by pressing the hygrostat button
(6) several times (30–75 % and continuous operation “CO”). The symbol
on the display (12) blinks during input. After 3 seconds without input, the
selected value is saved. The symbol changes to the current measured
humidity.
Info: Once the desired air humidity is reached, the appliance stops and
the display blinks. Should the measured current air humidity fall below
the set value, the appliance begins to humidify again. We recommend
that you set your room humidity to 45–60 % (comfort range).
4. Press the button for selecting the humidification level (7) to change the
fan speed (levels 1–4 + Turbo). Pressing multiple times increases the
level from 1 to “Turbo” and starts again at 1 when you continue tapping.
The selected level is shown on the display (12) by bars (2 bars = level 1, 4
bars = level 2, 6 bars = level 3 , 8 bars = level 4 and “TU” for Turbo). The
symbol on the display (12) blinks during input. After 3 seconds without
input, the selected value is saved. The symbol changes to the current
measured humidity. Level 2 is the default setting.
5. Press the auto mode button (8) to activate the auto mode. “Auto Mode”
appears on the display (12). In auto mode, the unit adapts the humidifica-
tion output level automatically in order to reach and maintain the desired
humidity quietly and in an energy-efficient way. First, set the hygrostat
(6) to the desired humidity (30–75 %). The greater the difference be-
tween the current humidity and the desired target humidity, the higher
the humidification output level will automatically be set (> 10 % = level
4, 7–9 % = level 3, 4–6 % = level 2, < 3 % = level 1). The auto mode can
not be activated when the hygrostat (6) is set to continuous operation
(“CO”). As soon as you press the button for changing the humidification
level (7) (or the auto mode button (8) again), auto mode is deactivated.
6. If you find the lamps too bright (in a bedroom for example), you can re-
duce the brightness of the LEDs by pressing the dimmer button (9). You
can choose between three different modes:
•
Normal mode (default mode)