Текст страницы
Adjustment of disc mechanical brakes
Before adjusting the disc brakes, make sure that the brake discs are not deformed, that the brake
pads are flat and not scored..
— Fix the cable to the brake lever so that the
distance between the pads and the rim is 1 - 2
mm.
— Install the caliper of the disc brake so that the
brake surface of the pads is strictly parallel to the
plane of the brake disc, fix the caliper bolts..
— Pressing the brake lever, if necessary, adjust
the distance between the brake pads and the
wheel rim with the adjusting screw.
— Using the adjusting screw, install the stationary
brake pad so that it is as close as possible to the
brake disc, but does not touch it when the wheel
rotates.
— Adjust and fix the brake cable so that when you press the brake lever it does not reach the
handlebar 2-3 cm. If necessary, use the adjusting screw on the brake handle..
— Using the adjusting screws on the brake levers,
achieve an even divorce of the brake levers.
— As the brake pads wear and stretch the cables, adjust the cable tension with the adjusting
screw on the brake handle or with the screw securing the cable on the brake lever, while not
allowing the adjusting screw to be screwed into the brake lever by less than 5 mm.
— As a rule, complete grinding of disc brakes occurs after 100 - 200 km of run.
79
78