Текст страницы
8
EN
BEFORE THE FIRST USE
• Secure the base using the fastening screws.
• Gently insert the power plug into the lock in the base
(1) (Fig. 3).
• Make sure that the base (1) is properly secured.
After the unit’s transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using it.
REMOTE CONTROL
ATTENTION! A lithium battery is used in the remote
control. To avoid danger, do not allow children to play
with the battery. If your child has swallowed a battery,
immediately see a doctor.
Battery installation/replacing
• Press on the clamp and remove the battery holder
(26) from the remote control (22) body, insert a
CR2025 battery (are not included) into the holder,
strictly following the polarity (pic. 5).
• Install the battery holder (26) into the remote control
(22).
Notes:
• Unpack the unit and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specified specifications of power
supply voltage of the unit correspond to the
specifications of your mains. No additional settings
required when using the device in the mains with 60
Hz frequency.
• Wipe the fan body with a slightly damp cloth and then
wipe it dry.
FAN ASSEMBLY
-
if there is an isolation insert in the battery holder
(26), remove the insert;
-
replace the battery in time;
-
do not recharge the lithium battery CR2025;
-
remove the battery if you are not planning to use
the unit for a long time;
-
remove the used battery from the remote control
(22) and dispose of it.
• When using the remote control, aim it at the front
upper part of the fan body.
• The fan is supplied with its base (1) disassembled.
Do not switch the fan on without the base (1).
• Align the two halves of the base (1) and connect
them so that the locks would trigger (Fig. 1).
• Thread the power cord through the central hole in the
base (1) (Fig. 2).
• Insert the lower part of the fan body into the central
hole in the base (1).