Текст страницы
1. Disable Fast Startup and the built-in battery. See “Before you replace any CRU” on page 33.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See “Base cover assembly” on page 34.
Step 1.
Remove the memory module as shown below.
Step 2.
Install the memory module as shown below.
M.2 solid-state drive and M.2 solid-state drive bracket
Follow the instructions to replace the 2242 M.2 solid-state drive.
Before you start, read Generic Safety and Compliance Notices.
Attention: If you replace a M.2 solid-state drive, you might need to install a new operating system..
36
Linux User Guide