Текст страницы
Driver installation
Install the Realtek USB GBE Ethernet Controller Driver available for your system.
This is available for download at www.dell.com/support under the “Driver and
download” section.
Network (RJ45) data rate through USB-C/Thunderbolt max speed is 2500 Mbps.
Wake-on-LAN behavior
Computer power
save state
System behavior after receiving Wake-on-Lan
(WOL) command
Modern Standby (S0ix)
Computer and monitor remain in Standby mode but the
network communication is enabled.
Standby/Sleep (S3)
Both the computer and monitor are turned ON.
Hibernate (S4)
Both the computer and monitor are turned ON.
OFF/Shutdown (S5)
Both the computer and monitor are turned ON.
NOTE: The computer BIOS must be configured to enable WOL function
first.
NOTE: This LAN port is 1000Base-T IEEE 802.3az compliant,
supporting Mac Address (Printed on model label) Pass-thru (MAPT),
Wake-on-LAN (WOL) from standby mode (S3) and UEFI* PXE Boot
function [UEFI PXE Boot is not supported on Dell Desktop PC’s (except
for OptiPlex 7090/3090 Ultra Desktop)], these 3 features depend on
BIOS settings and version of the OS. Functionality may vary with non-
Dell PC’s.
*UEFI stands for Unified Extensible Firmware Interface.
NOTE: WOL S4 and WOL S5 are capable only with Dell Systems that
support DPBS and are with Thunderbolt/USB-C (MFDP) interface
connection.
NOTE: Any issue related to WOL, users should debug the computer
without the monitor. After the problem is solved, then connect to the
Monitor.
About your monitor │ 37