Текст страницы
23
English
Problem
Cause
Solution
Descale your machine first and then install
the AquaClean water filter.
English
I cannot activate the
AquaClean water filter
and the machine asks for
descaling.
The filter has not been installed or
replaced in time after the
AquaClean water filter light
started to flash. This means your
machine is not completely
limescale free.
The new water filter does
not fit.
Only the AquaClean water filter fits into
the machine.
You are trying to install another
filter than the AquaClean water
filter.
The rubber ring on the AquaClean
water filter is not in place.
Place back the rubber ring on the
AquaClean water filter.
The machine is making a
loud noise.
It is normal that your machine
makes noise during use.
If the machine starts to make a different
kind of noise, clean the brew group and
lubricate it (see 'Lubricating the brew
group').
The AquaClean water filter was
not prepared properly and air is
now drawn into the machine.
Remove the AquaClean water filter from
the water tank and properly prepare it for
use before you place it back. See chapter
'AquaClean water filter' for step-by-step
instructions.
The water tank is not fully
inserted and air is drawn into the
machine.
Make sure the water tank is in the correct
position: remove it and insert it again
pushing it as far as possible.
Technical specifications
The manufacturer reserves the right to improve the technical specifications of the product. All the preset
quantities are approximate.
Description
Value
Size (w x h x d)
247x366x434 mm
Weight
7 - 7.5 kg
Power cord length
1000 mm
Water tank
1.8 litres, removable
Coffee bean hopper capacity
275 g
Coffee grounds container capacity
12 pucks
LatteGo (milk container) capacity
250 ml
Adjustable spout height
85-145 mm
Nominal voltage - Power rating - Power supply
See data label on inside of service door (fig. A11)