Текст страницы
FAQ
When you press MJN or MKN to adjust the volume, the beep continues to sound.
R Check the connection setting mode of the Bluetooth® device. If the Bluetooth® device has settings such as Absolute
Volume or Enhanced Mode, try changing the settings and adjusting the volume.
Reset to factory settings
You can reset to the factory settings (default settings upon purchase) when you want to delete all pairing information in
the unit.
Charge the battery before resetting the unit.
1
In the power-off state, press and hold MUN for at least 5 seconds until the LED starts blinking alternately red
and blue.
2
While the LED is blinking alternately red and blue, press and hold MJN and MKN at the same time for at least
5 seconds.
R The default settings are restored after the LED blinks blue quickly and the unit turn off.
Note:
R To pair a Bluetooth® device with the unit again, delete the pairing information (device name) on the Bluetooth® device
that was paired with the unit, and then pair the unit with the Bluetooth® device again. (Page 5)
Firmware updates
If it is necessary to update the firmware for the unit, we will post a notification on the following website.
https://panasonic.jp/support/global/cs/audio/download/index.html#headphone
Maintenance
R Wipe with a soft, dry cloth.
R Do not use solvents such as benzine, thinner, alcohol, kitchen detergent, or chemical wipes because they may alter or
damage the exterior.
R If you will not use the unit for long periods, fully charge it once every 6 months to maintain the performance of the
internal battery.
Removing the batteries when disposing of this unit
When disposing of this unit, remove the batteries installed in this unit and recycle them.
When disposing of the batteries, please contact your local authorities or dealer and ask for the correct method of
disposal.
Important:
R The following instructions are not intended for repairing purposes but for disposal of this unit.
R Wait until the battery has fully run out before disassembling.
R Regarding handling of the used battery:
– Insulate the terminals with adhesive tape or similar material.
– Do not disassemble the battery itself.
1
Remove the right ear pad.
11