Текст страницы
8
EN
• Hot water resulting from the first boilings is not recommended
to consume, you may use it for domestic needs.
USING THE ELECTRIC KETTLE
• Place the kettle on a solid steady flat and non-slip non-
metal surface away from heat sources as far as possible
from the edge of the surface.
WATER BOILING
• Take the handle (10), pull it upwards and remove the lid
(9).
• Fill the kettle with water not lower than the «MIN» mark
and not higher than the «MAX» mark on the scale
located on the inner surface of the flask (1).
• Close the lid (4) and place the kettle filled with water on
the kettle stand (7).
Note: always make sure that water drops do not fall on the
contact unit of the kettle stand (7).
• Insert the power cord plug into the mains socket, you will
hear a sound signal, the illumination of all symbols and
control buttons will light up, the digital symbols (9) will
display the water temperature in the kettle flask (1).
• Press and hold the on/off button(17) «
» (fig. 2), you
will hear a sound signal, the temperature setting buttons
(14, 15) «
,
», the on/off button (17) «
» and button
for turning on the water temperature maintaining function
(16) « » will light up on the control panel (2), the
temperature of water heating in the kettle flask (1) will be
displayed in digital characters (9).
• Insert the power cord plug into the mains socket, you
will hear a sound signal, the illumination of all symbols
and control buttons will light up, the digital symbols (9)
will display the water temperature in the kettle flask (1).
• Press and hold the on/off button (17) «
» (fig. 2), the
temperature setting buttons (14, 15) «
,
», the on/
off button (17) «
» and the button for turning on the
function of water temperature maintenance (16) « »
will light up on the control panel (2), the water heating
temperature of 100°C will be displayed in digital
characters (9).
• While the kettle is operating, the digital characters (9)
will show the water heating temperature in the kettle
flask (1).
• Upon completion of the water boiling mode, you will
hear a sound signal.
• The backlight of the buttons (14, 15) «
,
» and the
button (16) « » will go out, the digital characters of
the water heating temperature (9) will go out after 30
seconds, the backlight of the On/Off button (17) «
»
will go into standby mode.
• Remove the kettle from the base (7) and carefully pour
out boiled water into a suitable bowl (fig. 3).
• Remember that there is boiling water inside the kettle
flask (1), always hold the kettle only by the handle (6),
do not tilt the kettle sharply, in case of careless use of
the kettle you can get burns by hot water.
• Repeat the water boiling procedure several times.
ATTENTION! To avoid burns by hot steam, do not bend
over the spout (3).