Текст страницы
How to Use
EN EN Before Use
6. Add Water to the Clean Water Tank
3. Remove Robot Protections, and Install the Side Brush and Mop Assembly
Turn On/Off
in this manual. Please follow the instructions based on the current app version.
• To disconnect the device from Wi-Fi network, press and hold the Reset button on the
robot for 3 seconds.
Take out the clean water tank from the base station and fill up the tank with
clean water. Then install it back into the base station.
5. Connect the Robot to the Base Station
①
Side Brush Clip
Press and hold the power button for 3 seconds to turn on the robot. The power
indicator will remain lit. Or, place the robot onto the base station by aligning
the charging contacts of the robot with those of the base station, and then the
robot will turn on automatically and begin charging. To turn off the robot, move
the robot away from the base station and press and hold the power button for 3
seconds.
②
Fast Mapping
Press and hold the power button on the robot for 3 seconds to turn it on.
Place the robot onto the base station with the mop assembly facing toward the
washboard. Then you will hear a voice notification when the robot successfully
connects to the base station. After the robot is fully charged, the status
indicators on the robot and the base station will remain lit for 10 minutes and
will then dim.
4. Connect with the Dreamehome App
After configuring the network for the first time, follow the instructions in the
app to quickly create a map. The robot will start mapping without cleaning.
When the robot returns to the base station, the mapping process has been
completed and the map will be saved automatically.
Pause/Sleep
(1) Press and hold the power button on the robot for 3 seconds to turn it
on. Open the robot cover and scan the QR code on the robot, or search
"Dreamehome" in the app store to download and install the app.
(2) Open the Dreamehome app, tap "Scan QR code to connect" and scan the
same QR code on the robot again to add the device. Please follow the prompts
to finish the Wi-Fi connection.
Note: Do not add hot water into the water tank, as this may cause the tank to become
deformed.
When the robot is running, press any button to pause it.
If the robot is paused for more than 10 minutes, it automatically enters sleep
mode. All indicators on the robot will turn off. Press any button on the robot, or
use the app to wake up the robot.
Wi-Fi Indicator
Note: If the robot is paused and placed onto the base station, the current cleaning process
will end.
· Blinking slowly: To be connected
· Blinking quickly: Connecting
Auto Resume Cleaning
QR Code
· On: Connected
Note: It is recommended to fully charge the robot before its first use. When the robot cannot
If the battery is too low, the robot will automatically return to the base station to
charge. After charging to the appropriate battery level, it will resume unfinished
cleaning tasks.
be turned on after the battery is depleted, manually connect the robot with the station to
charge it.
Note:
Note: To use this function, please enable it in the app.
Do Not Disturb (DND) Mode
- Only 2.4 GHz Wi-Fi is supported.
- To reset Wi-Fi, repeat step (2) and then follow the prompts to finish the Wi-Fi connection.
- Due to upgrades in the app software, the actual operations may differ from the directions
When the robot is set to the Do Not Disturb (DND) mode, the robot will be
8
9