Текст страницы
EN
EN
Routine Maintenance
Routine Maintenance
Dust Bag
Side Brush
Washboard Filter
Main Brush
1. Remove the dust tank cover and discard the dust bag.
Remove and clean the side brush.
1. Press the brush guard clips inwards to remove the brush guard and lift the
1. Take out the robot and remove the washboard filter after the mop pad
cleaning is complete.
brush out of the robot.
Mop Pad Holders
Note: Pulling upwards on the handle will seal the bag to prevent the dust and debris from
Remove and clean the mop pad holders.
accidentally falling out.
2. Rinse the washboard filter with clean water, wipe it clean, and then reinstall
it in the washboard.
2. Remove the dust and debris from the filter with a dry cloth.
2. Pull out the brush covers at both ends of the brush as shown in the figure.
Omnidirectional Wheel
Use a proper cleaning tool to remove any hair tangled in the brush. Reinstall the
3. Use the app or press the button to return the robot to the base station, or
manually put the robot back.
brush covers on both ends of the brush, and then reinstall the brush. Press on
the brush guard to lock it in place.
3. Install a new dust bag and reinstall the dust tank cover.
Note:
Note: During cleaning, do not make the robot return to the base station.
• Use a tool such as a small screwdriver to separate the axle and tire of the omnidirectional
wheel. Do not use excessive force.
• Rinse the omnidirectional wheel under the running water and put it back after drying it
completely.
12
13