Текст страницы
Note:
EN
EN
Routine Maintenance
How to Use
Parts
To keep the robot in good condition, it is recommended to refer to the accessory usage in the app or the following table for routine maintenance.
prevented from resuming cleaning. The DND mode is disabled by default at
the factory. You can use the app to enable the DND mode or modify the DND
period. The DND period is 22:00-8:00 by default.
• To ensure the robot easily returns to the base station after cleaning, it is recommended to
make the robot start from the base station.
• The mop pads will be cleaned before the robot starts mopping, please wait patiently.
• Do not move the base station, the clean water tank, the used water tank, or the
washboard filter during operation.
• To prevent scalding, do not touch the water outlet while the base station is operating.
Note:
Part
Maintenance Frequency
Replacement
Period
Part
Maintenance Frequency
Replacement
Period
• The scheduled cleaning tasks will be performed on time during the DND period.
• The robot will resume cleanup where it left off after the DND period expires.
Used water tank
After each use
Laser Distance Sensor
(LDS)
Spot Cleaning
/
Clean water tank
2. Auto mop washing
When cleaning, the robot will automatically return to the base station to wash
mop pads based on the mop pad cleaning frequency specified in the app. The
base station will automatically refill the robot's water tank and the robot will
resume cleanup.
Carpet sensor
Main brush
Every 6 to 12 months
When the robot is awaiting, press briefly the button
to enable the spot
cleaning mode. In this mode, the robot cleans a square-shaped area of
Cliff sensors
Once every month
Once every 2 weeks
Dust box's filter
1.5 x 1.5 meters around it and returns to its starting point once the spot cleaning
is completed.
Bumper window
3. Automatically empty the dust box and wash and dry the mop pads
After the robot finishes a cleaning task and returns to the base station to
charge, the base station will automatically empty the dust box and then wash
and dry the mop pads.
/
Every 3 to 6 months
Side brush
Note:
Robot Restarting
Bumper
Mop pad holders
/
• If the auto-empty function is turned off in the app, the base station will not automatically
Bottom of the robot
Washboard filter
Once every 1 to 2 months
/
empty the dust box.
• The base station will empty the dust box according to the setting in the app.
If the robot stops responding or cannot be turned off, press and hold the power
button for 10 seconds to forcefully turn it off. Then, press and hold the
power button for 3 seconds to turn the robot on.
Dust box
Base station's signaling
area
Vacuum and Mop
Clean it as needed
Main wheels
4. Clean the used water tank
After the robot has completed its task, please clean the used water tank to
prevent any odor.
Note: When using the robot for the first time, the robot will default to "Vacuum and Mop"
Charging contacts
Dust bag
Every 2 to 4 months
/
Auto-empty vents
Once every month
/
Mop pads
Every 1 to 3 months
Omnidirectional wheel
mode. To adjust the cleaning mode, go to the Cleaning Mode settings in the app and select
from the following three additional options:
① Mop after Vacuuming
② Vacuum
③ Mop
3D line laser sensor
Edge sensor
1. Start cleaning
Press the power button on the robot, or use the app to make the robot start
from the base station. Then the robot will plan the optimal cleaning route and
perform the cleaning task based on the created map.
Note: The frequency of maintenance and replacement depends on actual usage.
If an exception occurs due to special circumstances, prompt maintenance or
replacement is recommended.
10
11