Текст страницы
Step 0:
No pendulum action;
Step I:
Small pendulum action;
Step II:
Medium pendulum action;
Step III:
Large pendulum action.
Make sure that the blank part is tightly fastened and
that all of the metal pieces (nails, screw nails, etc.)
have been removed from it.
Turn the power tool on before the saw blade
comes in contact with the blank part. Do not use extra
force; the operation requires some time. Extra force
will not speed up the operating process, but it will over-
load the tool.
When the teeth of the saw blade
are too large for
the blank part (excessive vibration, splitting and chipping
of the processed surface will serve as a sign of the teeth
being too large), turn off the power tool immediately and
replace the saw blade
with the appropriate blade.
If the saw blade
jams during the operation, turn off
the power tool immediately and try to expand the saw cut,
then carefully remove the saw blade
from the saw cut.
off and then remove the saw blade
from the saw cut.
When cutting certain materials (like met-
als), the saw blade may heat up ex
-
cessively, therefore it is recommended
to use cooling or lubricating substances
which are to be applied to the point where the saw
blade comes in contact with the blank part.
3
It is recommended to consider the following rec-
ommendations when selecting the degree of the
pendulum rate:
when the edge of the saw cut must be exact and
clean, select small pendulum rate or switch the pen-
dulum rate off;
switch the pendulum rate off when processing thin
(sheet metal, sheet plastic, etc.) or hard materials
(alloy-free steel, non-ferrous metals, etc.);
when sawing soft materials (soft wood, etc.) se-
lect large pendulum rate; it will increase the speed
of the operation, however the quality of the saw cut
may be reduced.
Plunge sawing may be used only when
sawing soft materials, such as wood,
plasterboard, etc. This operating tech-
without preliminary drilling - the saw blade 15 cuts
plied using
short saw blades
It is recommended to make a test saw
cut using a spare piece of the blank part
(made of the same material as the blank
part to be processed) after the pendulum
rate is selected.
Position the power tool on the front edge of the base
plate
3
Protection against contact with saw blade
blank part with the saw blade
by pressing the power
tool to the blank part.
Once the saw blade
Contact protector prevents accidental contact with saw
blade
and improves safety of work performance.
cuts through the blank part
return the power tool into its normal operating position
and continue cutting along the marked line.
4
Recommendations on the power tool op-
eration
The parallel guide for parallel sawing
Selecting the saw blade
allows saw-
ing along the existing straight edge as well as cutting
Saw blades of T-type may be used
with all of the jigsaw models.
• Loosen wing screws .
• Position the parallel guide for parallel sawing.
• Set the needed sawing distance.
• Tighten wing screws
for circular /
parallel sawing.
• Saw by pressing the parallel guide for parallel saw-
ing
to the side edge of the blank part.
Before starting the operation, please select the appro-
priate type of the saw blade
which should corre-
spond to the sawed material, sawing regime and the
quality of the edge of the saw cut. The designation of
the saw blade is printed on the package; you may also
ask the salesperson.
General guidelines for cutting
Similar results can be reached by attach-
ing a board to a work part with screw
clamps and using such board as a sec-
ondary limit stop. Perform sawing by
moving power tool along the limit stop while
pressing the side of base plate to the side of the
board.
Make a test saw cut using a spare piece of
the blank part (made of the same material
as the material of the blank part) in order
to make sure that the saw blade , the
sawing speed and the pendulum strike have been
selected appropriately.
10
English