Текст страницы
Long-term switching on / off
Installation and regulation of power tool
elements
Switching on:
Push on / off switch and lock it in the position with
lock-on button
Before carrying out any works on the power tool it
must be disconnected from the mains.
.
Switching off:
Push and release on / off switch .
Mounting / dismounting / setting-up of
some elements is the same for all power
Dust suction during the power tool op-
eration
are not indicated in the illustration.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
The inserting / replacing of the saw blade (see
Dust suction allows reducing dust concen-
tration in the air and prevents its accumula-
tion at the workplace.
When working with the power tool always
use a suction cleaner to suck off the dust form the
treated materials.
As a result of the long use the saw
Design features of the power tool
Stroke rate selection
the sharp cutting edges may injure the
user, therefore one must always use
protective gloves when inserting / replacing the
saw blade 15.
Using the thumbwheel for stroke rate selection one
may select the needed number of stroke of the saw
blade
(also when operating the power tool).
Push on / off switch and lock it in the position with
lock-on button .
By moving the thumbwheel for stroke rate selec-
tion , select the needed number of stroke of the saw
blade
.
Attention: observe the following rules upon the in-
serting of the saw blade :
the teeth of the saw blade
must face for-
ward;
the claws on the stem of the saw blade
should
rest upon the saw holder ;
the saw blade
guide roller .
1-2 (low stroke rate) - use when sawing hard and
solid materials (alloy-free steel, non-ferrous metals
and their alloys, etc.);
3 (medium stroke rate) - use for sawing less
hard materials (plastic, plywood, particleboards,
hard wood, etc.);
4-5 (high stroke rate) - use for sawing soft mate-
rials (soft wood, insulating materials, etc.).
Move sleeve of saw holder
(this will unlock the clamping mechanism of the saw
holder and allows you to insert / replace the saw
blade
).
Insert / replace saw blade
Move sleeve of saw holder
(this will lock the clamping mechanism of the saw
holder ).
Installation and removal of vacuum cleaner adapt-
2
Following setting up the number of stroke
rate of the saw blade 15 it is recommend-
ed to make a test saw cut using a spare
piece of the blank part (made of the same
material as the part to be processed).
shows vacuum cleaner adapter mounting / dismou-
nting operations.
When operating your power tool at a low speed for a
long time, it has to be cooled down for 3 minutes. To
do it, set a maximum stroke rate and leave your power
tool to run idle.
Pendulum rate selection
Initial operation of the power tools
Always use the correct supply voltage: the power sup-
ply voltage must match the information quoted on the
Switching the power tool on / off
Short-term switching on / off
To switch on, press and hold on / off switch , to switch
off - release it.
Pendulum rate facilitates selecting the optimal sawing
regime (feed velocity, the appearance of the saw cut,
etc.) for the processed material.
With each downward move the saw blade
is driven
back from the blank part which improves the release of
the sawdust, reduces the heating up and increases the
operating life of the saw blade
. Moreover the reduc-
tion of the feed force allows the worker to operate the
instrument without getting tired.
The degree of the pendulum strike may be changed
when operating the power tool. The lever for pendulum
stroke adjustment
allows setting four steps of the
pendulum stroke:
9
English