Текст страницы
7
EN
• If the power cord is damaged, it should be replaced
by the manufacturer, a maintenance service or similar
qualified personnel to avoid danger.
• Do not repair the unit by yourself. Do not disassemble
the unit by yourself, if any malfunction is detected, and
after it was dropped, unplug the unit and apply to the
service center.
• Transport the kettle in the original package.
• Keep the unit out of reach of children and disabled
persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
OR LABORATORY PURPOSES.
BEFORE USING THE KETTLE
base correspond to the specifications of your mains.
When using the kettle in the mains with 60 Hz frequency,
the unit does not need any additional settings.
• Wipe the outer and inner surface of the flask (1) with a
slightly damp cloth then wipe dry. Do not use abrasives
and coarse scourers for this purpose.
• Place the base (8) on a solid steady flat and non-slip
non-metal surface away from heat sources as far as
possible from the edge of the surface.
• Do not place and do not use the kettle in closed space,
for example, in the cupboard or in closed structures —
this can lead to its breakage, cause harm to the user or
damage to his/her property.
• Before connecting the kettle, make sure that there are no
moisture drops on the base (8), the flask (1), the power
cord and the power plug.
Note: the inside of the Base (8) has a Storage (9)
compartment for winding the power cord. Adjust the cord to
the optimal length and place it accordingly.
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the kettle and remove all packing materials and
advertising stickers.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the kettle for damages, in case of damage do
not plug it into the mains.
• Make sure that the specifications of power supply
voltage specified on the lower panel of the unit or the
• Take the Lid Handle (5) and remove the Lid (4).
• Fill the Kettle with water up to the «MAX» mark on the
Gauge (7).
• Close the Lid (4) and make sure that the Lid (4) is tightly
closed.
• Place the Kettle on the Base (8).
• Plug the power cord into an electrical outlet. You will hear
a sound signal and the Digital Indication (10) will show
the temperature of water inside the Kettle Jug (1), as well
as the Indication (11).
• Press the «
» Power Button (17) - the Digital Indication
(10) will display the temperature of «100». The Boiling