Текст страницы
8
EN
• Close the Lid (4) and set the filled Kettle on the Base (8).
Note: always make sure that no water droplets get on the
contact group of the Kettle Base (8).
Indication (13) « » will flash on the Control Panel (2)
for three seconds, after which the heating element will
turn on and the water will be heated to 100 degrees.
• To cancel the boiling mode, press the «
» Power
Button (17) a second time.
• You will hear two sound signals once the Boiling Mode
is no longer active.
• Remove the Kettle from the Base (8) and carefully pour
the boiled water into a suitable container.
• Remember, the Kettle (1) contains boiling water. Always
hold the Kettle by the Handle (6) and avoid tilting it
abruptly. Mishandling the Kettle can cause burns from
hot water.
• Repeat the water boiling procedure several times.
ATTENTION! To avoid burns from hot steam, do not
lean over the Spout (3).
• The hot water from the initial boils is not recommended
for consumption. You can use it for household
purposes.
USING THE ELECTRIC KETTLE
• Plug the power cord into an electrical outlet - you will
hear a sound signal and the Digital Indication (10) will
show the water temperature inside the Kettle Jug (1).
• Press the «
» Power Button (17) - the Digital Indication
(10) will display the temperature of «100», the « » Water
Boiling Indication (13) will flash on the Control Panel (2)
for three seconds, after which the heating element will
turn on and the water will be heated to 100 degrees.
• During the heating of water in the Kettle Jug (1), the
color of the Digital Indication (10) changes based on the
water temperature: up to 49 degrees - blue, from 50 to
59 degrees - green, from 60 to 69 degrees - indigo, from
70 to 79 - purple, from 80 to 89 - yellow, 90 degrees and
above - red.
• To cancel the boiling mode, press the «
» Power Button
(17) a second time.
Note: the Digital Indication shows the values dependent on
the volume of water volume inside the Kettle Jug (1) and
may slightly deviate from the readings obtained by other
measuring devices, especially with minimal water levels.
• Place the Kettle Base (8) on a firm, stable, level, non-
slip, and non-metallic surface, away from heat sources
and as far from the edge of the surface as possible.
BOILING WATER
• You will hear two sound signals once the Boiling Mode is
no longer active.
Notes: after boiling water, water droplets may form on
the Base (8) due to steam condensation; this is a normal
occurrence and not covered by the warranty;
• Take the Lid Handle (5) and remove the Lid (4).
• Fill the Kettle with water, ensuring the water level is not
below the «MIN» mark and not above the maximum
«MAX» mark on the Gauge (7).