Текст страницы
16. Flange
sink so that it aligned with the support ring.
17. Drain pipe with a knee
2. DISCONNECTION OF THE DROP HORN AT
TENTION!
4. Pressing tightly to the bottom of the sink
rubber gasket, cardboard gasket, support ring and
mounting ring, slide the snap ring (7) onto the
flange of the sink so that it snaps into the flange
groove.
5. Tighten the three fixing screws (6) to The fixing
assembly was tight and evenly pressed to the sink.
5. CLEANING THE DRAIN PIPE
At the time of installation of the device is
recommended Wear safety glasses. Loosen the nut
on the top of the water trap with a pipe wrench.
relative humidity not more than 80%. Loosen the
nut on the top of the extension pipe. Remove the
extension pipe.
If you do not clean the drain pipe, it can clog.
Loosen the nut at the bottom of the washing
flange.
1. Remove the water trap.
Push the washing flange upwards through drain
hole of the sink and remove it.
2. Using a cleaner, remove all solid precipitation in
the horizontal part of the drainage pipes, moving
with side of the siphon towards the main pipe.
CLEAN THE WASH FAN WRAPPING PLACE FROM
THE SEALANT OR THE GARBAGE.
IF THE DISHWASHER WILL NOT BE CONNECTED TO
THE DISPOSER, GO TO PART 7 OF THIS INSTRUCTION
NOTE: It may be necessary to expand the drain
hole for installation flange fastening disposer.
Equipment for extending the drainage hole is
purchased separately.
6. CONNECTING THE DISHWASHER MACHINES
AND TRANSFER CONNECTION
3. DISASSEMBLY OF THE ASSEMBLY UNIT
If the sink is full of liquid it can be discharged into
the disposer through the inlet in its upper parts.
• Turn over the assembly and loosen the three
fixing screws (1) The access to the ring (2).
On all models inside the intake pipe there is
partition. The partition must be removed.
• Disconnect the retaining ring from the flange
with a screwdriver. Now the assembly unit can be
disassembled.
7. CONNECTING THE DISPOSER TO THE FIXING
UNIT ATTENTION!
4. ATTACHING THE FIXING ASSEMBLY TO WASH
ING Fig.5.1.
To avoid injury, follow the so that during the
removal and installation of a part Your body was
not under the disposer; during the installation it is
possible to drop it.
ATTENTION! To install the disposer, the thickness
of the sink in the area of the drain hole should be
no more than 18 mm.
Remove any objects from the grinding chamber
product before installing it on the sink.
1. Install the product in such a way that provide
easy access to the restart button engine located in
the lower part of the body. Do not block this place
with any objects.
1. Install one or two rubber gaskets (2) under the
washing flange (1). Make sure that The drainage
hole is not clogged, and set to flange washer /
gasket. In order to The flange of the sink became
in place, you need to crush it with a heavy load. (To
avoid scratches, use a towel as a lining.)
2. Place the disposer with three mounting loops (1)
into the sliding position by mounting rails (2).
2. Put the second rubber part on the bottom of
the kitchen sink a gasket (2), a cardboard gasket
(optional) (3) and a metal support ring (4) (flat side
up).
3. Lift the disposer, insert the top end (installation
gasket) in the mounting and turn the setting ring
to the right (with a wrench or adjustable pliers)
until the mounting loops are fixed with respect to
the mounting rails.
Make sure that all three mounting loops are locked.
3. While holding the second rubber gasket,
cardboard padding (optional) and a metal support
ring, put the mounting ring (5) on the flange of the
12