Текст страницы
Disposer is installed.
• If you are not qualified enough, call an electrician
to connect the product to the power.
4. Run water into the sink, then check the
connections for leaks.
• If a three-pin grounding-type plug is used to
connect a three-contact outlet with ground.
5. Insert the noise absorbing screen into the drain
hole flat side up.
• Do not modify the design of the plug supplied
with the device.
8. CONNECTING THE OUTLET PIPE
• Improper equipment grounding may cause
electric shock current.
To the DRAIN PIPE ATTENTION!
• All electrical connections must comply with the
electrical and norms.
• It is recommended to wear protective goggles
when installing the disposer.
• Do not connect the ground to the feed pipe gas.
• Use a sanitary sealant only for connecting the
flange of the sink with the disposer.
• Do not power on the distribution shield until you
have installed the sockets with proper grounding.
• If the power cord is damaged, it must be replaced
at the service center.
Do not use sealants for threaded pipe connections
or anaerobic screwed sealants. They can damage
the product.
• Regularly check the disposer and fittings for
water leaks, since leaks water can cause damage
to property.
NOTE: Access to a grounded outlet is required.
Installing all additional outlets must be carried out
by a qualified electrician, and all outlets must be
properly grounded.
The manufacturer is not responsible for damage to
property as a result of water leaks.
Turn ON/OFF device
Depending on the models BORT disposer are
equipped with two types of control: a wireless
(wall) switch or a pneumatic switch.
1. Assemble the steel wire clamp onto the
discharge tube, insert the discharge tube into the
outlet seal, clamp it with steel wire clip.
Wireless (wall) switch
The disposer of the “Control and FullControl” series
are equipped with a wireless wall mount switch.
2. Rotate disposal to make the discharger tube
and water outlet U drain trap in the same level
(to prevent water leakage, do not pull or bend
discharge tube to disposal to U drain trap). If
discharge tube is too shot, you can purchase an
extension from hardware store. (Disposal must
remain in vertical position to prevent vibration)
The switch should be located in a convenient (safe
for children) place above the table top.
Ensure lower mounting ring is still securely locked
over ridges on mounting flange.
For instal the switch to the wall, use double-sided
tape.
For activate / deactivate the device, hold down the
key for 2-3 seconds.
INSTALLING THE DRAINAGE SYSTEM
Battery type: Voltage: 12V; Size: A27
1. Put the flange (2) on the drain pipe Insert the
rubber seal (1). Fasten drain tube, tightly pulling it
to the body disposer with screws (4).
Air switch
Disposer is equipped with an air switch and a
connecting pipe (except “Control” series).
9. CONNECTING THE DISPOSER TO THE ELECTRI
CAL NETWORK
ATTENTION! ELECTRIC SHOCK CURRENT
INSTALLATION OF AIR SWITCH
• To prevent electric shock, turn off the power
before installing or servicing the product.
1. Drill a hole with a diameter of 32 mm in suitable
top or top the panel of a sink. Some sinks may
13