Инструкция измельчитель пищевых отходов Bort TITAN Extra

Страница 14 (стр. 14 из 48)

Бренд: Bort

Страница 14 документа Измельчитель пищевых отходов Bort TITAN Extra. Раздел: Техника для кухни. Бренд: Bort.

Текст страницы

already have a suitable A hole for the opening of
which is necessary remove the cover.

Do not allow the following items to fall into the
disposer: shells, including oyster, caustic means for
cleaning pipes or similar chemical products, glass,
porcelain or plastic, large (hollow) bones, metal
objects (bottle caps, cans, or kitchen appliances),
hot fat or other hot liquids.

2. Unscrew the nut from the body of the push
button, while holding the stainless steel washer
and rubber gasket in place. Place one end of the
PVC tube on the spout on the body Press the other
end to A hole in the table top and a nut located
under the countertop.

• Replace worn noise glossy screen / installation
gasket / protective reflector if they are worn and
are no longer able to prevent waste or water.

3. Place the push button housing in the hole and
tighten the nut underneath countertop (enough
arm effort). Do not use the key to tighten nut.

• If the disposer is switched off, use a stopper to
prevent foreign objects in the grinding camera.
Make sure that the power of the disposer is
disabled.

• Before pressing the reset button, cleaning the jam
or removing foreign objects from the shredding
chamber, make sure that the food is turned off.

• Keep hands and fingers out of the reach of
disposer chamber.

4. Take the other end of the duct and tightly put
it on the spout of the air switch located on the
bottom of the disposer. Hand tighten the clamping
nut. The disposer installation is complete. Before
using the product, read all of the instructions.
operation and safety contained in paragraph 10 of
this manual. In conclusion, install the plug in the
sink in the Closed position. Fill the sink with water,
Remove the plug and check the connections on
the a water leakage.

FIRE RISK:

10. ATTENTION! IMPORTANT INSTRUCTIONS
FOR SAFETY

• If the air switch does not work, remove the plug
power supply from the outlet and check the air
duct pneumatic switch and delivered to the outlet
electricity.

To minimize the possibility of Do not store near
fire extinguishing articles such as rags, paper or
aerosol cans. Do not store or use gasoline or other
flammable vapor-gas mixtures and liquid near
the disposer. Do not allow the following camera
products: paints, solvents, household cleaning
agents and chemicals, automotive liquids, plastic
packaging.

USER’S MANUAL

1. Use air switch for starting disposer.

• This product is designed for grinding food
residues at home; the ingress of substances other
than food into the disposer may cause injury and /
or damage property. To reduce the risk of Do not
use a washer with an installed disposer not for
food purposes (for example, for bathing a child or
washing your head).

2. Slowly lower food waste into the chamber and
install the filter grid in a vertical position (so that
it flows through it water) to reduce noise and
possible throwing waste during grinding.

• Children should be supervised adults and should
not play with a disposer. To reduce the risk of injury
It is necessary to keep a watchful eye on children
use of the product.

3. After the grinding is completed, turn off the
disposer and let the water run for at least 15 s to
flush the drain line.

SHOULD

• If the wedging in the disposer is eliminated,
turn off the appliance and disconnect it from the
electrical network. Use a wrench for self-removal
of jammed waste according to description in the
section “Elimination of jamming disposer “.

• Grind food waste under pressure cold water not
less than 6 liters / min.

• Use tongs or pliers to remove foreign objects
from the product.

• Grind solids, such as small bones and fruit
residues, for cleaning chopping chambers.

• Grind citrus fruits, melons, vegetables and coffee
beans.

• To reduce the risk of injury from particles that are
thrown out by the disposer, it is prohibited to use
grinders withoutnoise shielding screen. Place the
plug in the drain hole.

• After the grinding is finished, let the water run out
at least 15 seconds to flush the drain pipeline.

14