Текст страницы
11
EN
• When the ice generator has finished operating, switch
it off by pressing the On/Off button «On/Off» (17) and
unplug the power cord from the mains socket.
CLEANING AND CARE
IMPORTANT!
• Wash the ice basket (18) and ice scoop (20) with warm
water and neutral detergent, rinse and dry them.
• If there is dirt on the infrared diode (9) and photodetector
(13), wipe them with a dry cloth.
• Keep the ventilation grid (4) clean, you can clean it with
a vacuum cleaner using a respective attachment.
• Wipe the ice generator body (1) with a damp cloth, then
wipe dry. If necessary, use a neutral detergent.
• Do not allow liquid to enter the ice generator body (1).
• Do not use wire brushes, abrasive cleaners or solvents.
STORAGE
• Before taking the ice generator away for long storage,
unplug it and allow the unit to warm up to room
temperature.
• Clean the ice generator.
• Before storing the ice generator, make sure the inner
surfaces are completely dry.
• Store the ice generator upright in a cool, dry place out of
the reach of children and disabled people.
TROUBLES AND TROUBLESHOOTING
Malfunction
Possible reason
Solution
The ice generator is
not switched on.
No electricity at the
mains socket.
Plug a known working
electrical device into the
mains socket.
-
Clean the ice generator at least once a week.
-
After cleaning, make sure the inner surfaces of the
ice generator are dry, otherwise mold may form.
• Before cleaning the ice generator, switch it off by
pressing the On/Off button «On/Off» (17) and unplug
the power cord from the mains socket.
• Allow the ice generator to warm up to room
temperature.
• Do not immerse the ice generator, the power cord or
the power plug into water or any other liquids.
• If there is any water left in the tank, pour it out. To do
this, pull out the unit to a distance of 60 mm from the
table (Fig. 2), place a suitable container to collect water
and pull out the drain plug (11) (Fig. 3).
• Open the lid (2) of the ice generator and pull out the
basket (18) by holding the handles (19).
• Wipe the inner surface of the ice generator with a soft
cloth soaked in a 1:1 solution of table vinegar. After
this, rinse the inner surface with clean water and drain
all water.
The power cord is not
fully inserted into the
mains socket.
Make sure the power
cord is firmly inserted
into the mains socket.
Attention! To avoid damages, do not clean the
evaporator (5).
• Reinstall the drain plug (11) (Fig. 1).
instr BR6301.indd 11
instr BR6301.indd 11
06.05.2024 11:05:09
06.05.2024 11:05:09