Текст страницы
9
EN
TIPS
filled with ice again. The ice generator operates
fully automatically; you do not need to control its
operation.
For reasons of hygiene, it is not recommended to
use ice from the first preparation cycle.
BEFORE USING THE ICE GENERATOR
After transporting or storing the unit at low
temperatures, it must be kept at room temperature
for at least 3 hours.
• Do not use the ice generator at a temperature below
5°C.
• The ice generator is designed to operate in ambient
temperatures between 10°C and 32°C.
• Fill the tank with water at a temperature between 8°C
and 25°C.
• Place the ice generator on a flat, stable surface with
a minimum distance of 15-20 cm from the wall or
furniture to the ice generator.
• Provide easy access to the power cord plug to
quickly disconnect the ice generator.
• Do not install the unit at an angle of slope of more
than 45 degrees.
• Do not overturn the ice generator; if the ice generator
has been overturned, install it correctly and wait at
least 2 hours before switching it on.
• Fill the tank with water at room temperature that has
been purified by household
• water filters. Do not pour hot water into the tank as
this may damage the ice generator.
• Due to rapid freezing, the ice may have a «milky»
color due to the air contained in the water, but this
does not affect the quality of the ice.
• If you need pure ice, use boiled, pre-cooled drinking
water.
• Unpack the ice generator and remove all packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the ice generator for damages; if it is
damaged, do not plug it into the mains.
• Make sure that the supply voltage specified on the
label matches that of the mains.
• Wipe the ice generator body (1) and the inner surface
with a damp cloth, then wipe it dry.
• Open the lid (2), remove the ice basket (18) by
holding the handles (19), wash the ice basket (18)
and ice scoop (20) with warm water and neutral
detergent, rinse and dry.
• Place the carrying handle (4) in place (Fig. 1).
Slightly unclench the handle (4) and insert it at an
angle into the holes on the body (1), make sure that
the handle is installed correctly.
• Make sure that the drain plug (11) is in place (Fig. 1).
instr BR6301.indd 9
instr BR6301.indd 9
06.05.2024 11:05:09
06.05.2024 11:05:09