Текст страницы
11. Addressable Gen2 header
The Addressable Gen2 header allows you to connect individually addressable RGB
(ARGB) WS2812B LED strips or WS2812B based LED strips.
ADD GEN2_1
ADD GEN2_2
ADD GEN2_3
CAUTION! Before you install or remove any component, ensure that the power supply is switched
off or the power cord is detached from the power supply. Failure to do so may cause severe
damage to the motherboard, peripherals, or components.
NOTE:
• The Addressable Gen2 header supports addressable RGB LED strips (5V/Data/Ground), with
a maximum power rating of 3A (5V). Additionally, the addressable header on this board can
support up to 120 LEDs per header in Gen1 mode, or a combined maximum of 500 LEDs in
Gen2 mode.
• Actual lighting and color will vary with LED strip.
• If your LED strip does not light up, check if the addressable RGB LED strip is connected in the
correct orientation, and the 5V connector is aligned with the 5V header on the motherboard.
• The addressable RGB LED strip will only light up when the system is powered on.
12. Alteration PCIe Mode switch
The Alteration PCIe Mode switch allows you to switch the PCIe signal which comes
from the CPU from between Gen4 or Gen3 for the PCIe slot.
ALT_PCIE_MODE
NOTE:
• When the Alteration PCIe Mode switch is set to Auto, the PCIe signal from the CPU will be the
default setting.
• When the Alteration PCIe Mode switch is set to 1st step, the PCIe signal from the CPU will be
Gen4, and LED1 will light up green.
• When the Alteration PCIe Mode switch is set to 2nd step, the PCIe signal from the CPU will be
Gen3, and LED2 will light up yellow.
• The nearby LEDs indicate which PCIe mode is currently selected.
27